69913 Tyco Electronics, 69913 Datasheet - Page 4

• Manufacturer Part Number: 69913
• Description: DIE SOLIS 69082 400MCM
• Manufacturer: Tyco Electronics

Specifications of 69913

• Lead Free Status / RoHS Status: Not applicable / Not applicable

however, amount of use, working conditions, operator
training and skill, and established company standards
should determine frequency of inspection. The
inspection should be performed in the following
sequence:
A. Visual Inspection
B. Die Closure Inspection
Every die set is inspected and tested for proper die
closure before packaging. An inspection should be
performed periodically to check the die closure for
excessive wear.
4
Crimping Die Assemblies 69911, 69912, 69913, and 69914
of 5
1. Remove all lubrication and accumulated film by
immersing the dies in a suitable commercial
degreaser that will not affect paint or plastic
material.
2. Make sure all die holding screws are in place
and secured.
3. Check all bearing surfaces for wear. Replace
worn components.
4. Inspect the crimp section for flattened, chipped,
cracked, worn, or broken areas. See Figure 5. If
damage is evident, the dies must be repaired
before returning them to service. See Section 7,
REPLACEMENT AND REPAIR.
Pitted
Chipped
Figure 5
Tyco Electronics Corporation
Broken
The die closure inspection requires the use of a plug
gage conforming to the dimensions provided in
Figure 6. Tyco Electronics does not manufacture or
market these gages. Proceed as follows:
If the dies meet the plug gage conditions, the dies are
considered dimensionally correct, and should be
lubricated with a THIN coat of any good SAE 20
motor oil. If not, the die assembly must be returned to
Tyco Electronics for further evaluation and repair.
Refer to Section 7, REPLACEMENT AND REPAIR.
For additional information regarding the use of plug
gages, refer to Instruction Sheet 408–7424.
7. REPLACEMENT AND REPAIR
The parts listed in Figure 8 are customer–
replaceable. A complete inventory can be stocked
and controlled to prevent lost time when replacement
of parts is necessary. Order replacement parts
through your Tyco Electronics Representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 1–717–986–7605, or write to:
8. REVISION SUMMARY
Since the previous release of this document, the
following changes were made:
1. Remove traces of oil or dirt from the die closure
surfaces, bottoming surfaces, and plug gage.
2. Assemble and position dies to meet the “gage
dimension” indicated in Figure 7.
3. With dies properly positioned, check the die
closure using the proper plug gage. Hold gage in
straight alignment with the die closure and carefully
try to insert, without forcing, the GO element. See
Figure 7. The GO element must pass completely
through the wire barrel crimp die closure.
4. Try to insert the NO–GO element. The NO–GO
element may enter partially, but must not pass
completely through the wire barrel crimp die
closure.
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
S Updated document to corporate requirements
S Added part number 69914 to title, Section 1,
INTRODUCTION; Section 2, DESCRIPTION;
tables in Figures 2, 6, and 8
408-2671
Rev
B