69732 Tyco Electronics, 69732 Datasheet - Page 3

• Manufacturer Part Number: 69732
• Description: DIE PIDG STRATO 69710 22-20AWG
• Manufacturer: Tyco Electronics

Specifications of 69732

• Lead Free Status / RoHS Status: Not applicable / Not applicable

D
D
7. Allow the handles to open fully, and remove the
crimped terminal or splice.
8. For a splice, reposition the uncrimped insulation
barrel in the stationary die. If the splice cannot be
turned, turn the tool. Close the handles until the
splice is held firmly in place, insert the stripped
wire, and complete the crimp.
!
D
Damaged product should not be used. If a
damaged product is evident, it should be cut from
the wire and replaced with a new one. DO NOT
re-terminate terminals or splices.
DIAMOND GRIP Terminals and Splices
PIDG STRATO-THERM Terminals
Figure 4
Figure 5
The insulation barrel crimping section of the moving
die has three crimp positions: 1–Tight, 2–Medium,
3–Loose. Adjust the insulation crimp as follows:
1. Turn both insulation crimp adjustment spacers
so that they fit into the notch in the side of the die.
See Figure 1. This is Position 3 or loose crimp
position.
i
PIDG terminals and splices and DIAMOND GRIP
terminals and splices feature an insulation grip".
Finished Crimp
Finished Crimp