58449-1 Tyco Electronics, 58449-1 Datasheet - Page 2

• Manufacturer Part Number: 58449-1
• Description: DIE HOLDER ASSY AMPLIMITE
• Manufacturer: Tyco Electronics
• Type: Die Holderr

Specifications of 58449-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

The subassembly has a slide base which mates with
the base plate of the power unit.
3. INSTALLATION OF DIE HOLDER ASSEMBLY
Select the appropriate die holder assembly and
proceed as follows:
3.1. Lower Die Holder Subassembly
Handle (Positioned
to Left Side)
2 of 8
DANGER
1. Loosen the screw securing the tool stop to the
base plate of the power unit.
2. Install the lower die holder subassembly onto
the base plate of the power unit, making sure that
the handle is positioned toward the left side of the
power unit.
3. Tighten the screw securing the tool stop to the
base plate.
Base Plate
Front of Pneumatic
Power Unit
Avoid personal injury. Air supply to the pneumatic
power unit must be turned OFF before starting
installation procedure.
Lower Die
Holder
Locating Hole(s) of
Guide Block
Ram Adapter
Upper Die
Holder
Tool Stop
(See Figure 2)
Lower Die Holder
Subassembly
Tyco Electronics Corporation
Figure 2
3.2. Upper Die Holder Subassembly
1. Mount the ram adapter to the mounting surface
of the ram, making sure that the guide pins are
positioned away from the front of the power unit.
2. Secure the ram adapter to the ram with the four
socket head cap screws provided with the die
holder assembly.
NOTE
3. Slide the lower die holder subassembly under
the ram until the subassembly is against the tool
stop of the base plate.
NOTE
i
i
The socket head cap screws must be loose
enough to allow the tooling to move on the ram
when the upper die holder is engaged with the
lower die holder.
The pins of the upper die holding plate must be
aligned with the locating holes of the guide block.
Upper Die Holding
Plate (Ref)
Pin(s)
(See Figure 2)
Stop
Guide Pin(s)
(Not Shown, Ref)
Rev B