58449-1 Tyco Electronics, 58449-1 Datasheet - Page 6

• Manufacturer Part Number: 58449-1
• Description: DIE HOLDER ASSY AMPLIMITE
• Manufacturer: Tyco Electronics
• Type: Die Holderr

Specifications of 58449-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

7. MAINTENANCE AND INSPECTION
It is recommended that a maintenance and inspection
program be performed periodically to ensure
dependable and uniform terminations. Frequency of
inspection should be adjusted to suit your
requirements through experience.
Frequency of inspection is dependent upon:
7.1. Daily Maintenance
For optimum tool performance and minimum
down--time, it is recommended that the following
steps of daily maintenance be performed.
6 of 8
5. After the ram has retracted to the upright
position, slide the lower die holder subassembly
out from under the ram and remove the crimped
connector assembly. Check the crimp height of the
connector assembly to ensure that the dimensions
conform to the termination requirements.
NOTE
1. The care, amount of use, and handling of the
die holder assemblies.
2. The degree of operator skill.
3. The presence of abnormal amounts of dust and
dirt.
4. Your own established standards.
1. Remove dust, moisture, and other contaminants
with a clean brush, or a soft, lint--free cloth. DO
NOT use objects that could damage the die holder
assembly or dies.
2. Make sure upper and lower die holder
subassemblies, cable clamp springs, and guide
block are in place and properly secured.
3. When the die holder assembly is not in use,
store it in a clean, dry area.
i
Various cable jacket insulation diameters may
affect the crimp height dimension. If different
cable manufacturers are used, check the crimp
height after each termination.
Tyco Electronics Corporation
7.2. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the die holder assembly and/or be
supplied to personnel responsible for the tooling.
These inspections should be performed in the
following sequence:
8. REPLACEMENT AND REPAIR
Customer--replaceable parts are listed in Figure 5.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics to ensure
quality and reliability. Order replacement parts
through your representative, or call 1--800--526--5142,
or send a facsimile of your purchase order to
717--986--7605, or write to:
For customer repair service, call 1--800--526--5136.
9. REVISION SUMMARY
Revisions to this instruction sheet include:
1. Remove all lubrication and accumulated film
with a suitable commercial degreaser that will not
affect paint or plastic material.
2. Make sure all die holding screws and assembly
components are in place. If replacements are
necessary, refer to Section 8, REPLACEMENT
AND REPAIR.
3. Inspect the crimp area of the dies for flattened,
chipped, cracked, worn, or broken areas. If
damage is evident, refer to Section 8,
REPLACEMENT AND REPAIR.
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
S
S
Updated instruction sheet to corporate
requirements
Instruction Sheet numbers were inverted in
SECTION 1,
(See Figure 5)
Rev B