69734 Tyco Electronics, 69734 Datasheet - Page 7

• Manufacturer Part Number: 69734
• Description: DIE PIDG STRATO 69710 #14
• Manufacturer: Tyco Electronics

Specifications of 69734

• Product: Punches & Dies
• Lead Free Status / RoHS Status: Not applicable / Not applicable

If the crimping chamber conforms to the gage
inspection, the dies may be considered dimensionally
correct and should be lubricated with a THIN coat of
any good SAE 20 motor oil. If the crimping chamber
DOES NOT conform to the gage inspection, the dies
must be returned for further evaluation and repair.
6. REPLACEMENT AND REPAIR
Customer--replaceable parts are listed in Figure 12.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by TE Connectivity to ensure
quality and reliability. Order replacement parts
through your representative, or call 1--800--526--5142,
Rev C
Wire Barrel Crimping
Section of Dies Bottomed,
But Not Under Pressure
Insulation Barrel
Crimping Section
of Dies
Inspection of Wire Barrel Section
“GO” Gage Must Pass Completely
Through Crimping Chamber
“NO- - GO Gage May Enter Partially,
But Must Not Pass Completely
Through Crimping Chamber
of Crimping Chamber
Gage
Element
Adjustment Spacers
in Position 3
Figure 11
or send a facsimile of your purchase order to
717--986--7605, or write to:
For customer repair service, call 1--800--526--5136.
7. REVISION SUMMARY
Revisions to this instruction sheet include:
Wire Barrel Crimping
Section of Dies Bottomed,
but Not Under Pressure
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
S
S
Updated document to corporate requirements
New logo
“GO” Gage Must Pass Completely Through
Insulation Barrel Section of Crimping Chamber
“NO- - GO Gage May Enter Partially, But Must Not
Pass Completely Through Insulation Barrel Section
of Crimping Chamber
Inspection of Insulation Barrel Section
of Crimping Chamber
Adjustment Spacers
in Position 1
408- 1632
Gage
Element
7 of 11