PDH10-37 Panduit Corp, PDH10-37 Datasheet - Page 9

• Manufacturer Part Number: PDH10-37
• Description: HOSE AIR SUPPLY
• Manufacturer: Panduit Corp
• Type: Accessory, Hoser

Specifications of PDH10-37

• Features: -
• For Use With/related Products: -

INSTALLATION CHECKLIST
1.
2. Is the main air supply hose to the dispenser clean and sized properly? (3/8" inside diameter minimum, 10'-0"
3. Is the filter element rating correct? (40 micron maximum)
4. Is the filter/regulator equivalent to recommended? (See Page 5.)
5. Are the quick-connect fittings equivalent to recommended? (See Page 5.)
6. Is the filter/regulator located as close to the dispenser as possible? (10' - 0" (3 m) maximum)
7. Is the dispenser placed or mounted in a convenient location? (Refer to the Dispenser Mounting
8. Is the regulated air line pressure to dispenser sufficient? (Refer to the Air Supply section on Page 5.)
LOADING PROCEDURE
1. Attach the XMR Reel Mount Assembly (See Figure 1) to the back of the dispenser (with reel axle facing the front
2. Plug the supplied electric cord into the receptacle on the back of the dispenser (See Figure 1). Plug the other
Have you made sure that the air supply is NON-LUBRICATED (from any source)?
(3 m) length maximum from filter/regulator to dispenser)
section on Page 6.)
of the dispenser) by positioning the larger holes in the reel mount assembly over the cap screws on the
dispenser, and sliding the reel mount assembly into position. Tighten the cap screws to fasten the reel mount in
position.
end into a grounded electrical outlet that matches the dispenser power requirements (Refer to the Electrical
Specifications section on Page 5). Set the power switch on the back of the dispenser (See Figure 1) to the "on"
position.
IMPORTANT: Only turn the power to the unit "on" or "off" using the power switch on the back of the dispenser.
The dispenser rotary receiver (Figure 2) will rotate slightly to align itself and the message "PANDUIT -- Tool is
ready" will appear on the electronic display (Figure 2) for two seconds. The dispenser is now ready for loading.
PAT1M/PAT1.5M: PA22222A01_03
Using any other method to turn the unit "on" or "off" may damage the unit.
PAT1M / PAT1.5M OPERATION MANUAL
Fig. 2
Page: 7 of 36
PDM DISPENSER
COMPONENT LIST
1. LCD Display
2. Display Menu Buttons
3. Feeder Hose Connection Block
4. Reel Collar
5. Tie Guide Door
6. Rotary Receiver
7. Tool Holder Bracket
Dec., 2007