MC908JL16CDWE Freescale Semiconductor, MC908JL16CDWE Datasheet - Page 183

• Manufacturer Part Number: MC908JL16CDWE
• Description: IC MCU 16K FLASH 8MHZ 28-SOIC
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908JL16CDWE

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: I²C, SCI
• Peripherals: LED, LVD, POR, PWM
• Number Of I /o: 23
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 28-SOIC (7.5mm Width)
• Controller Family/series: HC08
• No. Of I/o's: 23
• Ram Memory Size: 512Byte
• Cpu Speed: 8MHz
• No. Of Timers: 2
• Embedded Interface Type: I2C, SCI
• Rohs Compliant: Yes
• Processor Series: HC08JL
• Core: HC08
• Data Bus Width: 8 bit
• Data Ram Size: 512 B
• Interface Type: SCI
• Maximum Clock Frequency: 16 MHz
• Number Of Programmable I/os: 23
• Number Of Timers: 4
• Operating Supply Voltage: 2.7 V to 5.5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: FSICEBASE, DEMO908JL16E, M68CBL05CE
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 12 Channel
• For Use With: DEMO908JL16E - BOARD DEMO FOR MC908JL16
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

BCFE — Break Clear Flag Enable Bit
16.2.7 Low-Power Modes
The WAIT and STOP instructions put the MCU in low-power-consumption standby modes.
16.2.7.1 Wait Mode
If enabled, the break module is active in wait mode. In the break routine, the user can subtract one from
the return address on the stack if SBSW is set (see
logic zero to it.
16.2.7.2 Stop Mode
A break interrupt causes exit from stop mode and sets the SBSW bit in the break status register.
See
Freescale Semiconductor
This read/write bit enables software to clear status bits by accessing status registers while the MCU is
in a break state. To clear status bits during the break state, the BCFE bit must be set.
4.7 SIM
1 = Status bits clearable during break
0 = Status bits not clearable during break
Address: $FE03
Registers.
Reset:
Read:
Write:
BCFE
Bit 7
R
0
Figure 16-7. Break Flag Control Register (BFCR)
= Reserved
R
6
MC68HC908JL16 Data Sheet, Rev. 1.1
R
5
4.6 Low-Power
R
4
R
3
Modes). Clear the SBSW bit by writing
R
2
R
1
Break Module (BRK)
Bit 0
R
183