13193EVK-A00 Freescale Semiconductor, 13193EVK-A00 Datasheet - Page 23

• Manufacturer Part Number: 13193EVK-A00
• Description: KIT ZIGBEE RF MC13193
• Manufacturer: Freescale Semiconductor
• Type: 802.15.4/Zigbeer

Specifications of 13193EVK-A00

• Contents: Hardware, Software and Documentation
• Wireless Frequency: 2.4 GHz
• Interface Type: SPI
• Modulation: DSSS OQPSK
• Security: 128 bit AES
• For Use With/related Products: MC13193
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5.1.5 Running the TRIAX Software
1. Run the TRIAX Software from Windows Start menu ->Programs->Freescale->Triax.
After execution of the Triax program, the software prompts users to select the proper
communications port for their PC. This is the RS232 serial COM port to which the receiver
board (Board One) is connected.
5.1.6 Viewing Data
After selecting the appropriate communications port, several methods are available to view the
data being sent from the accelerometers on the transmitter board (Board One).
1. Sensor Data – This application shows the raw data that is sent from the accelerometer and
2. G Mouse – This application displays the location of the board based on movement of the
3. Tilt – This application translates the g’s experienced in each axis to an angle of rotation. To
4. Shipping – This application timestamps when a pre-determined threshold is violated or when
5.2 Range Demo Plus (SMAC)
The Range Demo Plus is a simple application that transmits data from one board to the other.
Signal strength is displayed via the LEDs on the
13192-SARD or the 13192-EVB.
Before running the Range Demo Plus, the 13192-SARD board must be flashed with the
following:
Before running the Range Demo Plus, the 13192-EVB board must be flashed with the following:
Follow the instructions shown in
Bootloader.
Freescale Semiconductor
sampled by the MCU analog/digital converter. The following data is provided.
transmitter board (Board One). To move the boxes on the display which represents the X, Y
axis, pick up the transmitter board and tilt it through different angles.
view different angles, rotate/tilt the transmitter board.
the board is turned upside down.
• range_demo_plus_rx_13192SARD_loader.s19
• range_demo_plus_tx_13192SARD_loader.s19
• range_demo_plus_rx_13192EVB_loader.s19
• range_demo_plus_tx_13192SEVB_loader.s19
X, Y, and Z accelerometer analog outputs in volts.
8-bit A/D readings (0-255).
The output of each axis converted into g’s.
If using batteries as the power source and the accelerometer
demonstration behavior becomes erratic, replace the batteries.
Section 5.8.2
802.15.4 EVK User’s Guide, Rev. 0.0
NOTE
to flash the board using the Embedded
board.
This test can be performed on either the
5-3