13193EVK-A00 Freescale Semiconductor, 13193EVK-A00 Datasheet - Page 25

• Manufacturer Part Number: 13193EVK-A00
• Description: KIT ZIGBEE RF MC13193
• Manufacturer: Freescale Semiconductor
• Type: 802.15.4/Zigbeer

Specifications of 13193EVK-A00

• Contents: Hardware, Software and Documentation
• Wireless Frequency: 2.4 GHz
• Interface Type: SPI
• Modulation: DSSS OQPSK
• Security: 128 bit AES
• For Use With/related Products: MC13193
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6. Click the “Close” button.
7. From the Test Tool program, run the Embedded Bootloader application by selecting the
8. Select the ZigBee device and click on the “OK” button.
9. To flash the board for the Range Plus Demo, select the
10. While the board is flashed, a progress indicator appears in the Embedded Bootloader
11. After the board is flashed, press the “Reset” button.
5.3.2 Board Two Setup (Transmit)
1. Connect the 13192-SARD or 13192-EVB to an RS232 serial COM port on the PC via the
2. Connect a power source (9V battery or the 9V power supply) to the board.
3. Power on the board. If all 4 LEDs are not on, press and hold down all 4 buttons (S101-S104
4. Run the “Test Tool” utility from the Start->Programs->Freescale Zigbee->Test Tool
5. From the “Test Tool” program, run the Embedded Bootloader application by selecting
6. Select the ZigBee device and click on the “OK” button.
7. To flash the board for the Range Plus Demo, select the
8. If you receive a Timeout error, highlight the file and click on the “Upload” button again.
9. While the board is being flashed, a progress indicator appears in the Embedded Bootloader
10. After the board is flashed, press and release the reset button.
5.3.3 Verifying Operation
Verify that the boards are communicating by ensuring that LED 1 on both boards is blinking.
LEDs 2 through 4 are signal strength indicators. As the boards are moved further apart, LEDs 4
through 2 will turn off in order. When the range of the boards is exceeded, LED 1 stops
blinking.
Freescale Semiconductor
“Embedded Bootloader” option from the “View” menu.
rx_range_demo_plus_13192SARD_SE_loader.s19 application file and click on the “Upload”
button.
If you receive a Timeout error, highlight the file and click on the “Upload” button again.
application.
included serial cable.
on the 13192-SARD and S1-S4 on the 13192-EVB) and press and release the Reset Button.
Then release all four buttons. All four LEDs should be on and the board is ready for flash
programming.
Windows menu.
“Embedded Bootloader” option from the “View” menu.
tx_range_demo_plus_13192SARD_SE_loader.s19 application file and click on the “Upload”
button.
application.
802.15.4 EVK User’s Guide, Rev. 0.0
5-5