PC28F00AP33TFA NUMONYX, PC28F00AP33TFA Datasheet - Page 61

• Manufacturer Part Number: PC28F00AP33TFA
• Description: IC FLASH 1GBIT P33 65NM 64EZBGA
• Manufacturer: NUMONYX
• Series: Axcell™r

Specifications of PC28F00AP33TFA

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 1G (64M x 16)
• Speed: 95ns
• Interface: Parallel
• Voltage - Supply: 2.3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-TBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 904253; 904253; PC28F00AP33TF 904253

P33-65nm
Appendix A Supplemental Reference Information
A.1
A.1.1
Table 29: Summary of Query Structure Output as a Function of Device and Mode
Datasheet
63
Common Flash Interface
The Common Flash Interface (CFI) is part of an overall specification for multiple
command-set and control-interface descriptions. This appendix describes the database
structure containing the data returned by a read operation after issuing the Read CFI
command (see
software can parse this database structure to obtain information about the flash device,
such as block size, density, bus width, and electrical specifications. The system
software will then know which command set(s) to use to properly perform flash writes,
block erases, reads and otherwise control the flash device.
Query Structure Output
The Query database allows system software to obtain information for controlling the
flash device. This section describes the device’s CFI-compliant interface that allows
access to Query data.
Query data are presented on the lowest-order data outputs (DQ
offset value is the address relative to the maximum bus width supported by the device.
On this family of devices, the Query table device starting address is a 10h, which is a
word address for x16 devices.
For a word-wide (x16) device, the first two Query-structure bytes, ASCII “Q” and “R,”
appear on the low byte at word addresses 10h and 11h. This CFI-compliant device
outputs 00h data on upper bytes. The device outputs ASCII “Q” in the low byte (DQ
and 00h in the high byte (DQ
At Query addresses containing two or more bytes of information, the least significant
data byte is presented at the lower address, and the most significant data byte is
presented at the higher address.
In all of the following tables, addresses and data are represented in hexadecimal
notation, so the “h” suffix has been dropped. In addition, since the upper byte of word-
wide devices is always “00h,” the leading “00” has been dropped from the table
notation and only the lower byte value is shown. Any x16 device outputs have 00h on
the upper byte in this mode.
Device Addresses
Section 6.2, “Device Command Bus Cycles” on page
Device
15-8
).
00010:
00011:
00012:
Offset
Hex
7-0
) only. The numerical
Order Number:208043-05
22). System
Code
Hex
51
52
59
ASCII
Value
"Q"
"R"
"Y"
Apr 2010
7-0
)