AH-5A BOGEN COMMUNICATIONS, AH-5A Datasheet - Page 34

• Manufacturer Part Number: AH-5A
• Description: Amplified Speaker/horn
• Manufacturer: BOGEN COMMUNICATIONS

Specifications of AH-5A

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

32
Accessories
Double Duty
The problem with selecting a tele-
phone line interface device is know-
ing exactly what type of line will be
available at the site. Because of mis-
takes in planning, a return trip to the
supply house is not that uncommon.
The TAMB was designed to eliminate
this problem.
The TAMB has the ability to interface
to ground start, loop start, and analog
ring-up lines. To make things even
easier, the TAMB doesn’t even need
a power supply when interfacing
with an analog ring-up line – it works
off of the talk battery. Punch down
two wires to connect the telephone
line, two wires to connect the paging
input... and you’re done. What could
be easier?
PRSLSI
Power Supply
(24V DC)
PRS48
Power Supply
(48V DC)
TELEPHONE INTERFACE
The TAMB interfaces a telephone system with a paging system allowing
announcements to be made through any telephone. Any of three types
of analog ports can be connected using the TAMB: loop start trunk,
ground start trunk, and station port (90V ring up). This wide range of port
compatibility makes the TAMB indispensable for any telephone paging
application because it eliminates the possibility of mismatching paging
interfaces and port types.
P r o d u c t F e a t u r e s :
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
announcement (defeatable)
of disconnect timer, silence interval timer, and Calling Party Control (CPC)
signal detection
station port
Loop start, ground start, and station port (90V ring up) compatibility
600-ohm output
Built-in confirmation tone indicating access to paging system (defeatable)
Built-in pre-announce tone produced over paging system before
Adjustable tone volume
Works with one-way and two-way (talk back) zones
Background music input with volume control
Suppresses background music during paging
Station access disconnect is dynamically controlled using a combination
Disconnect timer is adjustable from 6 to 35 seconds (defeatable)
Silence interval timer is adjustable from 2 to 6 seconds of silence
Calling Party Control (CPC) signal from switch immediately disconnects
No power supply needed for station port interfacing
1 Normally open contact pair available for operating external equipment
Punch-block connections (type 66)
FCC Part 68 approved
ETL listed
Wall-mount design
For trunk port interfacing, external-regulated 24V @ 90 mA
For station access, no power supply required.
or 48V DC @ 105 mA (not included).
Requirements
Power
Telephone
Access Module
TAMB
8-1/8" W x 4-1/2" H x 1-7/8" D
Dimensions
Product
Weight
2 lb.