CS8421-DZZR Cirrus Logic Inc, CS8421-DZZR Datasheet - Page 21

• Manufacturer Part Number: CS8421-DZZR
• Description: IC,Digital Audio Sample Rate Converter,CMOS,TSSOP,20PIN
• Manufacturer: Cirrus Logic Inc

7.1
DS641PP1
XTO
XTI
VD
GND
RST
BYPASS
ILRCK
ISCLK
SDIN
MCLK_OUT
TDM_IN
SDOUT
OSCLK
OLRCK
MS_SEL
GND
VL
SAOF
SAIF
SRC_UNLOCK
TSSOP PIN DESCRIPTIONS
PIN
10
12
13
14
15
16
17
18
19
20
11
1
2
3
4
5
6
7
8
9
Crystal Out (Output) - Crystal output for Master clock. See “Master Clock” on page 17.
Crystal/Oscillator In (Input) - Crystal or digital clock input for Master clock. See “Master Clock” on
page 17.
Digital Power (Input) - Digital core power supply. Typically +2.5 V.
Ground (Input) - Ground for I/O and core logic.
Reset (Input) - When RST is low the CS8421 enters a low power mode and all internal states are
reset. On initial power up RST must be held low until the power supply is stable and all input clocks
are stable in frequency and phase.
Sample Rate Converter Bypass (Input) - When BYPASS is high, the sample rate converter will be
bypassed and any data input through the serial audio input port will be directly output on the serial
audio output port. When Bypass is low the sample rate converter will operate normally.
Serial Audio Input Left/Right Clock (Input/Output) - Word rate clock for the audio data on the
SDIN pin.
Serial Audio Bit Clock (Input/Output) - Serial bit clock for audio data on the SDIN pin.
Serial Audio Input Data Port (Input) - Audio data serial input pin.
Master Clock Output (Output) - Buffered and level shifted output for Master clock. If MCLK_OUT
is not required, this pin should be pulled high through a 47 kΩ resistor to turn the output off. See
“Master Clock” on page 17.
Serial Audio TDM Input (Input) - Time Division Multiplexing serial audio data input. Grounded
when not used. See “Time Division Multiplexing (TDM) Mode” on page 18
Serial Audio Output Data Port (Output) - Audio data serial output pin. Optionally this pin may be
pulled low through a 47 kΩ resistor, but should not be pulled high.
Serial Audio Bit Clock (Input/Output) - Serial bit clock for audio data on the SDOUT pin.
Serial Audio Input Left/Right Clock (Input/Output) - Word rate clock for the audio data on the
SDOUT pin.
Master/Slave Select (Input) - Used to select Master or Slave for the input and output serial audio
ports at startup and reset. See Table 1 on page 13 for format settings.
Ground (Input) - Ground for I/O and core logic.
Logic Power (Input) - Input/Output power supply. Typically +3.3 V or +5.0 V.
Serial Audio Output Format Select (Input) - Used to select the serial audio output format at star-
tup and reset. See Table 3 on page 13 for format settings.
Serial Audio Input Format Select (Input) - Used to select the serial audio input format at startup
and reset. See Table 2 on page 13 for format settings.
SRC Unlock Indicator (Output) - Indicates when the SRC is unlocked. See “SRC Locking and
Varispeed” on page 15.
Table 4. TSSOP Pin Descriptions
CS8421
21