ISP1506ABS,557 NXP Semiconductors, ISP1506ABS,557 Datasheet - Page 23

• Manufacturer Part Number: ISP1506ABS,557
• Manufacturer: NXP Semiconductors

Specifications of ISP1506ABS,557

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Power Supply Requirement: Single
• Operating Supply Voltage (typ): 3.3V
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Lead Free Status / RoHS Status: Compliant

NXP Semiconductors
ISP1506A_ISP1506B_2
Product data sheet
Fig 6.
DATA[3:0]
REG1V8
REG1V8
V
detector
internal
CLOCK
internal
CC(I/O)
XTAL1
POR
V
NXT
STP
DIR
CC
t1 = V
t2 = ULPI pads detect REG1V8 rising above the REG1V8 regulator threshold and are not in 3-state. These pads may drive
either LOW or HIGH. It is recommended that the link ignores the ULPI pins status during t
t3 = The POR threshold is reached and a POR pulse is generated. After the POR pulse, ULPI pins are driven to a defined level.
DIR is driven to HIGH and the other pins are driven to LOW.
t4 = The internal PLL is stabilized after t
be stabilized after t
The DIR pin will remain LOW before the link issues a RESET command to the ISP1506.
t5 = The power-up sequence is completed and the ULPI bus interface is ready for use.
Power-up and reset sequence required before the ULPI bus is ready for use
CC
9.3.1 Interface protection
and V
CC(I/O)
t1
By default, the ISP1506 enables a weak pull-up resistor on STP. If the STP pin is
unexpectedly HIGH at any time, the ISP1506 will protect the ULPI interface by enabling
weak pull-down resistors on DATA[3:0].
startup(PLL)
t
PWRUP
are applied to the ISP1506. The ISP1506 regulator starts to turn on.
t2
from POR. The CLOCK pin starts to output 60 MHz. The DIR pin will transition from HIGH to LOW.
t3
startup(PLL)
t
startup(PLL)
Rev. 02 — 28 August 2008
. If the 19.2 MHz or 26 MHz clock is started before POR, the internal PLL will
t4
internal clocks stable
RESET command
TXCMD
D
ISP1506A; ISP1506B
internal reset
ULPI HS USB OTG transceiver
PWRUP
.
© NXP B.V. 2008. All rights reserved.
RXCMD
update
004aaa886
bus idle
t5
22 of 79