5962-8867809RX Cypress Semiconductor Corp, 5962-8867809RX Datasheet - Page 12

• Manufacturer Part Number: 5962-8867809RX
• Manufacturer: Cypress Semiconductor Corp

Specifications of 5962-8867809RX

• Lead Free Status / RoHS Status: Not Compliant

DSCC FORM 2234
APR 97
(original equipment), design applications, and logistics purposes.
prepared specification or drawing.
the individual documents. This coordination will be accomplished using DD Form 1692, Engineering Change Proposal.
application requires configuration control and the applicable SMD. DSCC will maintain a record of users and this list will be
used for coordination and distribution of changes to the drawings. Users of drawings covering microelectronics devices (FSC
5962) should contact DSCC-VA, telephone [phone].
[phone].
HDBK-103 have agreed to this drawing and a certificate of compliance (see 3.6 herein) has been submitted to and accepted by
DSCC-VA.
6. NOTES
6.1 Intended use. Microcircuits conforming to this drawing are intended for use for Government microcircuit applications
6.2 Replaceability. Microcircuits covered by this drawing will replace the same generic device covered by a contractor-
6.3 Configuration control of SMD's. All proposed changes to existing SMD's will be coordinated with the users of record for
6.4 Record of users. Military and industrial users shall inform Defense Supply Center Columbus (DSCC) when a system
6.5 Comments. Comments on this drawing should be directed to DSCC-VA, Columbus, Ohio 43218-3990, or telephone
6.6 Approved sources of supply. Approved sources of supply are listed in MIL-HDBK-103. The vendors listed in MIL-
5. PACKAGING
5.1 Packaging requirements. The requirements for packaging shall be in accordance with MIL-PRF-38535, appendix A.
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43218-3990
MICROCIRCUIT DRAWING
STANDARD
│
│
│ MIL-STD-883 test requirements
│
│
│
│ Interim electrical parameters
│ (method 5004)
│
│ Final electrical test parameters
│ (method 5004) for unprogrammed
│ devices
│
│ Final electrical test parameters
│ (method 5004) for programmed
│ devices
│
│ Group A test requirements
│ (method 5005)
│
│ Group C and D end-point
│ electrical parameters
│ (method 5005)
1/
2/ Any or all subgroups may be combined when using high speed testers.
3/ ** See 4.3.1c
4/ Subgroups 7 and 8 shall consist of verifying the data pattern.
TABLE II. Electrical test requirements.
* Indicates PDA applies to subgroups 1 and 7.
SIZE
A
│
│
│ (in accordance with
│ method 5005, table I)
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
1/ 2/ 3/ 4/
Subgroups
1*,2,3,7*,8A, 8B
1*,2,3,7*,8A,8B, 9
1,2,3,4**,7,8A,
8B,9,10,11
2,3,7,8A,8B
1
REVISION LEVEL
B
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
│
SHEET
5962-88678
12