20-101-1139 Rabbit Semiconductor, 20-101-1139 Datasheet - Page 85

• Manufacturer Part Number: 20-101-1139
• Description: RCM4310 RABBITCORE
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1139

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Data Bus Width: 8 bit
• Core Processor: Rabbit 4000
• Clock Speed: 58.98 MHz
• Interface Type: Ethernet
• Flash: 1 MByte
• Timers: 10 x 8 bit
• Operating Supply Voltage: 3.3 V
• Board Size: 72 mm x 47 mm x 21 mm
• For Use With/related Products: RCM4310
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1142

6.5 Run the PINGME.C Sample Program
Connect the crossover cable from your computer’s Ethernet port to the RCM4300 mod-
ule’s RJ-45 Ethernet connector. Open this sample program from the
ICMP
cable is connected from your computer’s Ethernet adapter to the RCM4300 module’s RJ-
45 Ethernet connector. When the program starts running, the green
RCM4300 module should be on to indicate an Ethernet connection is made. (Note: If the
LNK
with straight-through cables perhaps the power is off on the hub.)
The next step is to ping the module from your PC. This can be done by bringing up the
MS-DOS window and running the pingme program:
or by
and typing the entry
The ping routine will ping the module four times and write a summary message on the
screen describing the operation.
6.6 Running Additional Sample Programs With Direct Connect
The following sample programs are in the Dynamic C
folder.
•
•
•
RabbitCore RCM4300 User’s Manual
BROWSELED.C
Two “device LEDs” are created along with two buttons to toggle them. Users can use
their Web browser to change the state of the lights. The DS2 and DS3 LEDs on the Pro-
totyping Board will match those on the Web page. As long as you have not modified
the
your Web browser to bring up the Web page served by the sample program.
Otherwise use the TCP/IP settings you entered in the
PINGLED.C
LEDs DS2 and DS3 on the Prototyping Board when a ping is sent and received.
SMTP.C
the S2 and S3 switches on the Prototyping Board are pressed. LEDs DS2 and DS3 on
the Prototyping Board will light up when e-mail is being sent.
http://10.10.6.100.
light does not light, you may not be using a crossover cable, or if you are using a hub
Start > Run
folder, compile the program, and start it running under Dynamic C. The crossover
ping 10.10.6.101
ping 10.10.6.101
TCPCONFIG 1
—This program demonstrates using the SMTP library to send an e-mail when
—This program demonstrates ICMP by pinging a remote host. It will flash
—This program demonstrates a basic controller running a Web page.
macro in the sample program, enter the following server address in
SAMPLES\RCM4300\TCPIP\
TCP_CONFIG.LIB
LINK
SAMPLES\TCPIP\
light on the
library.
85