VX2110-01T-3CR1 SMC Corporation, VX2110-01T-3CR1 Datasheet - Page 44

• Manufacturer Part Number: VX2110-01T-3CR1
• Description: Process Solenoid Valve, 2 port, direct operated, 1/8 port, NC, 110VAC, conduit
• Manufacturer: SMC Corporation
• Type: Direct Operatedr

Specifications of VX2110-01T-3CR1

• Brand/series: VX Series
• Number Of Ports: 2
• Primary Type: Solenoid Valve
• Size, Port: 1⁄8" NPTF
• Voltage, Coil: 110 VAC
• Enclosure: Equivalent to IP65

1. As a rule, use electrical wire with a cross
2. Use electrical circuits which do not generate
3. Use voltage which is within 10% of the rated
4. When a surge from the solenoid affects the
sectional area of 0.5 to 1.25 mm
Furthermore, do not allow excessive force to
be applied to the lines.
chattering in their contacts.
voltage. In cases with a DC power supply
where importance is placed on responsive-
ness, stay within 5% of the rated value. The
voltage drop is the value in the lead wire
section connecting the coil.
electrical circuitry, install a surge voltage sup-
pressor, etc., in parallel with the solenoid.
Or, adopt an option that comes with the surge
voltage protection circuit. (However, a surge
voltage occurs even if the surge voltage
protection circuit is used. For details, please
consult with us.)
Caution
2 Port Solenoid Valve for Fluid Control
Precautions 3
Be sure to read this before handling.
For detailed precautions on each series, refer to the main text.
Wiring
2
for wiring.
∗ There is no polarity. (For the power saving type, there is polarity.)
∗ There is no polarity.
Since internal connections are as shown below for the DIN terminal,
make connections to the power supply accordingly.
Grommet
DIN terminal (Class B only)
• Use compatible heavy duty cords with cable O.D. of ø6 to 12 mm.
• Use the tightening torques below for each section.
Note) For an outside cable diameter of ø9 to 12 mm, remove the
DC (Class B only)
Gasket
Caution
Rated voltage
Class H coil: AWG18 Insulator O.D. 2.2 mm
Class B coil: AWG20 Insulator O.D. 2.5 mm
Terminal no.
DIN terminal
Other AC
100 VAC
200 VAC
Connector
internal parts of the rubber seal before using.
Binding head screw with flange
Tightening torque 0.5 to 0.6 N⋅m
Electrical Connections
1: +
Binding head screw
Tightening torque 0.5 to 0.6 N⋅m
(–)
Rubber seal
q
w
Washer
+
Black
Gray
Blue
+ (–)
Red
—
1
3
2: –
Lead wire color
(+)
Compatible cable
(Cable O.D. ø6 to 12 mm)
Back page 4
Gray
Blue
Red
Red
– (+)
2
Note)