TX09D70VM1CBA HITACHI, TX09D70VM1CBA Datasheet - Page 27

• Manufacturer Part Number: TX09D70VM1CBA
• Manufacturer: HITACHI

Specifications of TX09D70VM1CBA

• Lead Free Status / Rohs Status: Compliant

KAOHSIUNG HITACHI
ELECTRONICS CO.,LTD.
11. PRECAUTION IN DESIGN
11.1 PRECAUTIONS AGAINST ELECTROSTATIC DISCHARGE
11.2 HANDLING PRECAUTIONS
(1) As the adhesives used for adhering upper/lower polarizer’s and frame are made
(2) Lightly wipe to clean the dirty surface with absorbent cotton or other soft
(3) Immediately wipe off saliva or water drop attached on the display area because
(4) Fogy dew deposited on the surface may cause a damage, stain or dirt to the
(5) Touching the display area or I/F pins with bare hands or contaminating them are
(6) In general, the glass is fragile so that, especially on its periphery, tends to be
(7) Maximum pressure to the surface must be less than 1.96×10
(8) Since the metal width is narrow on these locations (see page 9-1/1), please careful
As this module contains C-MOS LSIs, it is not strong against electrostatic discharge.
Make certain that the operator’s body is connected to the ground through a list
band , etc.
And don’t touch I/F pins directly.
To prevent the display surface from damage and keep the appearance in good
state, it is sufficient, in general, to wipe it with absorbent cotton.
of
chemicals as acetone, toluene, ethanol and isopropyl alcohol. The following are
recommended for use :
normal hexane
Please contact with us when it is necessary for you to use chemicals other than
the above.
material like chamois, soaked in the recommended chemicals without scrubbing it
hardly.
Always wipe the surface horizontally or vertically. Never give a wipe in a circle.
it may cause deformation or faded color.
polarizer.
When you need to take out the LCD module from some place at low temperature
for test, etc.
It is required to be warmed them up to temperature higher than room temperature
before taking them out.
(Some cosmetics are detrimental to polarizer’s.)
cracked or chipped in handling. Please not give the LCD module sharp shocks
by falling , etc.
And if the pressure area is less than 1cm
1.96N.
prohibited, because the stain on the display area and poor insulation between
terminals are often caused by being touched with bare hands.
with handling.
organic substances which will be deteriorated by a chemical reaction with such
DATE Jan.18,’11
No.
Sh.
7B64PS 2711- TX09D70VM1CBA-6
2
, maximum pressure must be less than
4
Pa.
PAGE 11-1/2