TLE 8264-2E Infineon Technologies, TLE 8264-2E Datasheet - Page 46

• Manufacturer Part Number: TLE 8264-2E
• Manufacturer: Infineon Technologies

Specifications of TLE 8264-2E

• Packages: PG-DSO-36
• Transceiver: High Speed CAN ISO 11898 - 5 / 3 x LIN2.0 / J2602
• Voltage Regulator Output: 2 x 200 mA + 400 mA
• Watchdog: Standard and Window Watchdog
• Quiescent Current (max.): 28 ?A (typ) Sleep Mode (5V on)
• Standby Current: 58 ?A (typ) Stop Mode (5V on)

Figure 19
10.3.1
It is recommended to first set the LIN Wake Capable Mode before setting the SBC Sleep or Stop Mode to avoid
missing a wake up event. The reason is identical to the CAN behavior. For additional information, see
Chapter
Do not change the Transciever setting with the same SPI command that is used to sent the device to Sleep Mode.
10.4
10.4.1
The LIN transceiver has a feature implemented to protect the battery from running out of charge in case of a bus
short to GND. When the LIN transceiver is switched to Wake capable or Off, the internal pull-up resistor is switched
off to prevent a large current from flowing to GND. In addition, the transceiver only wakes up on a dominant-to-
recessive edge on the LIN bus, so with the bus shorted to GND the transceiver does not wake up.
10.4.2
As required by LIN 2.1, an oscillator clock tolerance < 2% for the protocol handler is possible with LIN transceiver.
10.4.3
The device fulfills the Physical Layer Specification of LIN 2.1.
The device fulfills the Physical Layer Specification SAE J2602-2.
Data Sheet
Reset (RO)
V
V
RxD
BUSX
cc 1µC
8.3.1.
LIN Wake capable
BUS
Idle
Timing during Transition from SBC Sleep to SBC Normal Mode
Transition from SBC Normal to Sleep / Stop Mode
Application Information
Bus Short to GND Feature
Oscillator Tolerance
LIN Specification
SBC Sleep mode
mode
PATTERN
WAKE
t
WU
LIN Waked
SPI command
Restart
mode
SBC
t
RDx
46
SBC Normal mode
LIN Normal mode
Communication
LIN WK from sleep to normal .vsd
starts
Rev. 1.0, 2009-03-31
LIN Transceiver
TLE8264-2E
t
t
t
t