HT45R37V Holtek Semiconductor Inc., HT45R37V Datasheet - Page 14

• Manufacturer Part Number: HT45R37V
• Description: C/r-f Type 8-bit Otp Mcu
• Manufacturer: Holtek Semiconductor Inc.

Note:
Rev. 1.00
TABRDC [m]
TABRDL [m]
Location 010H
This internal vector is used by the Timer/Event Coun-
ter 1. If a Timer/Event Counter 1 overflow occurs, the
program will jump to this location and begin execution
if the timer/event counter interrupt is enabled and the
stack is not full.
Location 014H
This internal vector is used by the Multi-function Inter-
rupt 0. The Multi-function Interrupt 0 vector is shared
by the SPI/I
When an interrupt signal is generated, the program
will jump to this location and begin execution if the in-
terrupt is enabled and the stack is not full.
Instruction
PC11~PC8: Current Program Counter bits
@7~@0: Table Pointer TBLP bits
Program Memory Structure
2
C and the C/R to F converter interrupt.
PC11
b11
1
PC10
b10
1
PC9
b9
1
PC8
b8
1
Table Location
@7
@7
b7
Table Location Bits
14
@6
@6
b6
Look-up Table
Any location within the Program Memory can be defined
as a look-up table where programmers can store fixed
data. To use the look-up table, the table pointer must
first be setup by placing the lower order address of the
look up data to be retrieved in the table pointer register,
TBLP. This register defines the lower 8-bit address of
the look-up table.
After setting up the table pointer, the table data can be
retrieved from the current Program Memory page or last
Program Memory page using the TABRDC[m] or
structions are executed, the lower order table byte from
the Program Memory will be transferred to the user de-
fined Data Memory register [m] as specified in the in-
struction. The higher order table data byte from the
Program Memory will be transferred to the TBLH special
register. Any unused bits in this transferred higher order
byte will be read as 0 .
The following diagram illustrates the addressing/data
flow of the look-up table:
TABRDL [m] instructions, respectively. When these in-
Location 018H
This internal vector is used by the Multi-function Inter-
rupt 1. The Multi-function Interrupt 1 vector is shared
by the Real Time Clock interrupt and Time Base inter-
rupt, A/D converter interrupt. When a interrupt signal
is generated, the program will jump to this location
and begin execution if the interrupt is enabled and the
stack is not full.
@5
@5
b5
@4
@4
b4
@3
@3
b3
@2
@2
b2
October 20, 2009
HT45R37V
@1
@1
b1
@0
@0
b0