ST-10M2 ELECTRONIC AUTOMATION, ST-10M2 Datasheet - Page 5

• Manufacturer Part Number: ST-10M2
• Description: Sequential Timers
• Manufacturer: ELECTRONIC AUTOMATION

www.DataSheet.co.kr
F r o n t P a n e l
1
2
Sequential Timer
 Potential free contacts should be used to short terminals C1 & C2 ,I1 & I2, S1&S2.Applying
 When more than one unit is used in cascade, output O1 & O2 should be connected to S1
 Do not connect O1& O2 to S1 & S2 of the same timer. Use C1 & C2 for cyclic or single
 Programming is not possible if terminals I1 & I2 are shorted.
 Apply Rated voltage to the timer to avoid permanent damage
power to these points will damage the timer permanently.
& S2 respectively of next timer.
cycle mode operation.
SEQUENCE
This button is used to select the required output / channel to program the timing.
ON / OFF
Quick Reference Guide
Datasheet pdf - http://www.DataSheet4U.net/