ST-10M2 ELECTRONIC AUTOMATION, ST-10M2 Datasheet - Page 8

• Manufacturer Part Number: ST-10M2
• Description: Sequential Timers
• Manufacturer: ELECTRONIC AUTOMATION

www.DataSheet.co.kr
P r o g r a m m i n g t h e T i m e r
I n i t i a t i n g a S e q u e n c e
T i m e r C a s c a d i n g
Sequential Timer
 Keep the PROG/RUN slide switch in the “PROG” position.
 Apply rated voltage across A1 and A2.
 By using the “SEQUENCE” button, select the required output, to program the timer.
 By using the “ON / OFF” button, select the “ON “and “OFF” time for particular output.
 By using the “RANGE “button, select the desired time range (sec/sec or min/sec or
 Set the required time by using “ADV” button.
 After programming the timer, keep the ”RUN/PROG” slide switch in “RUN“ position and the
 By shorting the S1 and S2 terminals on the front panel for a minimum period of 150
 The sequence starts with closure of “RLY0/OP1”as the case may be.
 S1 and S2 can be kept permanently shorted to start the sequence when in HOLD mode.
 In case of restart mode start signal is required every time a sequence has to be initiated.
 Short C1 and C2 of all the timers to be cascaded.
 Connect O1 and O2 of the first timer to S1 and S2 respectively of the second timer and so
hrs/min) as per requirement.
unit is ready for operation.
milliseconds, the timing is initiated.
on. (O1S1 – O2S2 and so on….)
Quick Reference Guide
Datasheet pdf - http://www.DataSheet4U.net/