ep2c35 Altera Corporation, ep2c35 Datasheet - Page 41

• Manufacturer Part Number: ep2c35
• Description: Cyclone Ii Device Family Data Sheet
• Manufacturer: Altera Corporation

Altera Corporation
February 2007
Note to
(1)
Maximum performance
Total RAM bits per M4K block (including parity bits)
Configurations supported
Parity bits
Byte enable
Packed mode
Address clock enable
Memory initialization file (.mif)
Power-up condition
Register clears
Same-port read-during-write
Mixed-port read-during-write
Table 2–6. M4K Memory Features
Maximum performance information is preliminary until device characterization.
Table
2–6:
Feature
(1)
Table 2–6
summarizes the features supported by the M4K memory.
250 MHz
4,608
2K × 2
1K × 4
512 × 8
512 × 9
256 × 16
256 × 18
128 × 32 (not available in true dual-port mode)
128 × 36 (not available in true dual-port mode)
One parity bit for each byte. The parity bit, along with
internal user logic, can implement parity checking for
error detection to ensure data integrity.
a data width of 1, 2, 4, 8, 9, 16, 18, 32, or 36 bits. The
byte enables allow the input data to be masked so the
device can write to specific bytes. The unwritten bytes
retain the previous written value.
Two single-port memory blocks can be packed into a
single M4K block if each of the two independent block
sizes are equal to or less than half of the M4K block
size, and each of the single-port memory blocks is
configured in single-clock mode.
used to hold the previous address value for as long as
the signal is enabled. This feature is useful in handling
misses in cache applications.
When configured as RAM or ROM, you can use an
initialization file to pre-load the memory contents.
Output registers only
New data available at positive clock edge
4K × 1
M4K blocks support byte writes when the write port has
M4K blocks support address clock enable, which is
Outputs cleared
Old data available at positive clock edge
Cyclone II Device Handbook, Volume 1
Description
Cyclone II Architecture
2–29