pip201-12m NXP Semiconductors, pip201-12m Datasheet - Page 16

• Manufacturer Part Number: pip201-12m
• Description: Pip201-12m-3 Dc-to-dc Converter Powertrain
• Manufacturer: NXP Semiconductors

Philips Semiconductors
16. Mounting
9397 750 11942
Product data
15.2 Rework guidelines
16.1 PCB design guidelines
Since the solder joints are largely inaccessible, only the side fillets can be touched
up. If there are defects underneath the package, then the whole package has to be
removed.
The first step in component removal is to reflow the solder joints. It is recommended
that the board is heated from the underside using a convective heater whilst hot air or
gas is directed at the upper surface of the component. Nozzles should be used to
direct the hot air or gas to minimize heating of adjacent components. Excessive
airflow should be avoided since this may cause the package to skew. An airflow
velocity of 15 to 20 liters per minute is usually adequate.
Once the solder joints have reflowed, the component should be lifted off the board
using a vacuum pen.
The next step is to clean the solder pads using solder braid and a blade-style
soldering tool. Finally, the pads should be cleaned with a solvent. The solvent is
usually specific to the type of solder paste used in the original assembly and the
paste manufacturers recommendations should be followed.
The terminals on the underside of the package are rectangular in shape with a
rounded edge on the inside. Electrical connection between the package and the
printed-circuit board is made by printing solder paste onto the PCB footprint followed
by component placement and reflow soldering. The PCB footprint shown in
is designed to form reliable solder joints.
The use of solder resist between each solder land is recommended. PCB tracks
should not be routed through the corner areas shown in
there is a small, exposed remnant of the leadframe in each corner of the package, left
over from the cropping process.
Good surface flatness of the PCB lands is desirable to ensure accuracy of placement
after soldering. Printed-circuit boards that are finished with a roller tin process tend to
leave small lumps of tin in the corners of each land. Levelling with a hot air knife
improves flatness. Alternatively, an electro-less silver or silver immersion process
produces completely flat PCB lands.
Rev. 03 — 19 November 2003
DC-to-DC converter powertrain
© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
PIP201-12M-3
Figure
20. This is because
Figure 20
16 of 20