M95040-WDW6TP STMicroelectronics, M95040-WDW6TP Datasheet - Page 11

• Manufacturer Part Number: M95040-WDW6TP
• Description: IC EEPROM 4KBIT 10MHZ 8TSSOP
• Manufacturer: STMicroelectronics

Specifications of M95040-WDW6TP

• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 4K (512 x 8)
• Speed: 10MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-TSSOP
• Organization: 512 x 8
• Interface Type: SPI
• Maximum Clock Frequency: 5 MHz
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 2.5 V
• Maximum Operating Current: 2 mA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 3.3 V, 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8679-2; M95040-WDW6TP

M95040, M95020, M95010
3
Connecting to the SPI bus
These devices are fully compatible with the SPI protocol.
All instructions, addresses and input data bytes are shifted in to the device, most significant
bit first. The Serial Data Input (D) is sampled on the first rising edge of the Serial Clock (C)
after Chip Select (S) goes low.
All output data bytes are shifted out of the device, most significant bit first. The Serial Data
Output (Q) is latched on the first falling edge of the Serial Clock (C) after the instruction
(such as the Read from Memory Array and Read Status Register instructions) have been
clocked into the device.
Figure 3
Only one memory device is selected at a time, so only one memory device drives the Serial
Data output (Q) line at a time, the other memory devices are high impedance.
The pull-up resistor R (represented in
bus master leaves the S line in the high impedance state.
In applications where the bus master might enter a state where all SPI bus inputs/outputs
would be in high impedance at the same time (for example, if the bus master is reset during
the transmission of an Instruction), the clock line (C) must be connected to an external pull-
down resistor so that, if all inputs/outputs become high impedance, the C line is pulled low
(while the S line is pulled high): this ensures that S and C do not become high at the same
time, and so, that the t
Figure 3.
1. The Write Protect (W) and Hold (HOLD) signals should be driven, high or low as appropriate.
CS3
SPI Interface with
(CPOL, CPHA) =
(0, 0) or (1, 1)
Bus master
CS2 CS1
shows an example of three memory devices connected to an MCU, on an SPI bus.
Bus master and memory devices on the SPI bus
SDO
SDI
SCK
R
R
SHCH
C Q D
S
requirement is met. The typical value of R is 100 k.
SPI mmory
Doc ID 6512 Rev 8
device
W
V
Figure
CC
HOLD
V
SS
R
3) ensures that a device is not selected if the
C Q D
S
SPI memory
device
W
V
HOLD
CC
Connecting to the SPI bus
V
SS
R
C Q D
S
SPI memory
device
W
V
CC
HOLD
AI12304b
V
11/43
SS
V
V
CC
SS