88-00143-85 Murata Wireless Solutions, 88-00143-85 Datasheet - Page 24

• Manufacturer Part Number: 88-00143-85
• Description: Zigbee / 802.15.4 Development Tools Hi Pwr Zigbee Module EVAL Kit
• Manufacturer: Murata Wireless Solutions

Specifications of 88-00143-85

• Rohs: yes
• Tool Is For Evaluation Of: SN3020
• Frequency: 2.45 GHz
• Interface Type: I2C, RS-232, SPI, UART, USB
• Operating Supply Voltage: 3 V
• Antenna Connector Type: Chip Antenna
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C

This device using the integrated antenna has been tested to comply with FCC CFR Part 15. The
device meets the requirements for modular transmitter approval as detailed in the FCC public notice
DA00.1407.transmitter given the following conditions:
*
calling emberInit and also within the main loop of EmberZNET stack. If the average of 5 samples exceeds
3450, then invoke halReboot to disable output power and restart the system.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures: reorient or relocate the receiving antenna, increase the separation between the equipment
and receiver, connect the equipment into an outlet on a circuit different from that to which the
receiver is connected, or consult the dealer or an experienced radio/TV technician for help.
11.1.1 FCC Labeling Requirements
When integrating the SN3020 into a product the FCC labeling requirements must be met. This
includes a clearly visible label on the outside of the finished product specifying the SN3020 FCC
identifier (FCC ID:QPU3020) as well as the notice above. The exterior label can use wording such
as “Contains Transmitter Module FCC ID:QPU3020” or “Contains FCC ID:QPU3020” although
any similar wording that expresses the same meaning may be used.
11.1.2 RF Exposure
This module has been certified for remote and base radio applications and is not intended to be
operated within 20cm of the body. If the module will be used for portable applications, the device
must undergo SAR testing.
The following statement must be included as a CAUTION statement in manuals for the products to
alert users on FCC RF exposure compliance:
SyChip/Murata Confidential
The voltage level may be monitored and sampled using emberMeasureVddFast or equivalent just prior to
• User must set the maximum output power level for the channel ranges listed below as
• Duty cycle of 67% allowed
• The application firmware must be written to disable power out if the source voltage is greater
• VBATT must be between 2.4V – 3.4V
defined by IEEE 802.15.4 [1] using emberSetRadioPower or equivalent under NORMAL
mode as specified in [2]:
than 3.4V*
o For channels 11 to 24, the value of -11
o For channel 25, the value of -17
o For channel 26, the value of -27
Page 24 of 26
SN3020 User Manual 1.1