88-00143-85 Murata Wireless Solutions, 88-00143-85 Datasheet - Page 25

• Manufacturer Part Number: 88-00143-85
• Description: Zigbee / 802.15.4 Development Tools Hi Pwr Zigbee Module EVAL Kit
• Manufacturer: Murata Wireless Solutions

Specifications of 88-00143-85

• Rohs: yes
• Tool Is For Evaluation Of: SN3020
• Frequency: 2.45 GHz
• Interface Type: I2C, RS-232, SPI, UART, USB
• Operating Supply Voltage: 3 V
• Antenna Connector Type: Chip Antenna
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C

“WARNING: To satisfy FCC RF exposure requirements for mobile transmitting devices, a
separation distance of 20cm or more should be maintained between the antenna of this device and
persons during operation. To ensure compliance, operations at closer distances than this are not
recommended.”
The term “IC” before the certification/registration number only signifies that the Industry Canada
technical specifications were met.
Le terme “IC” devant le numéro de certification /d’enregistrement signifie seulement que les
spécifications techniques Industrie Canada ont été respectées.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
The following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence (s). Son
utilisation est soumise à Les deux conditions suivantes: (1) cet appareil ne peut pas provoquer
d'interférences et (2) cet appareil doit accepter Toute interférence, y compris les interférences qui
peuvent causer un mauvais fonctionnement du dispositif.
This device complies with Health Canada’s Safety Code 6 / IC RSS-210. The installer of this device
should ensure that RF radiation is not emitted in excess of the Health Canada’s requirement.
Information can be obtained at:
lignes_direct-eng.php
Cet appareil est conforme avec Santé Canada Code de sécurité 6 / IC RSS-210. Le programme
d'installation de cet appareil doit s'assurer que les rayonnements RF n'est pas émis au-delà de
l'exigence de Santé Canada. Les informations peuvent être obtenues: http://www.hc-sc.gc.ca/ewh-
semt/pubs/radiation/radio_guide-lignes_direct-eng.php
The host device should be properly labeled to identify the module within the host device. The
Industry Canada certification label of a module shall be clearly visible at all times when installed in
the host device, otherwise the host device must be labeled to display the Industry Canada
certification number of the module, preceded by the words “Contains transmitter module”, or the
word “Contains”, or similar wording expressing the same meaning, as follows:
Contains transmitter module IC:4523A-SN3020
where 4523A-SN3020 is the module’s certification number.
This device has been tested and certified for use in the European Union.
SyChip/Murata Confidential
11.2 IC Notice (Canada)
11.3 CE Notice (Europe)
http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guide-
Page 25 of 26
SN3020 User Manual 1.1