SOIC8EV Microchip Technology, SOIC8EV Datasheet - Page 19

• Manufacturer Part Number: SOIC8EV
• Description: BOARD DEMO 8SOIC/MSOP/TSSOP/DIP
• Manufacturer: Microchip Technology

Specifications of SOIC8EV

• Mfg Application Notes: Interface Product Design Guide
• Main Purpose: Bare Evaluation Board
• Embedded: No
• Primary Attributes: 8- Pin SOIC/DIP/TSSOP/MSOP Evaluation Board
• Secondary Attributes: For PICmicro® MCUs, ADCs, DACs and other Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Utilized Ic / Part: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

© 2005 Microchip Technology Inc.
2.4.6
There may be occasions when it is desireable to convert the footprint of the device to
that of a DIP package. This allows the device to be installed into an exsisting DIP
socket. Two 1x4 row pins need to be installed into the PCB’s DIP footprint when the
device is installed into the appropriate package footprint.
This allows the PCB to convert the SOIC-8, MSOP-8 or TSSOP-8 footprints to a
300-mil DIP-8 footprint.
2.4.7
2.4.7.1
The following voltage supervisor is supported by this evaluation board.
TABLE 2-3:
2.4.7.2
When evaluating a voltage supervisor/voltage detector device, a minimum set of test
equipment should be available. Table 2-4 shows the recommended test equipment.
TABLE 2-4:
TC1232
Variable Power
Supply
Arbitrary Waveform
Generator
Digital Multi-Meter
(D.M.M.)
Oscilloscope
Test Light (LED)
Note 1:
Device
Hardware
The pad connection to connect to the V
device and the footprint option used.
The PCB as a SOIC-8, MSOP-8, or TSSOP-8 to DIP-8 Socket
Converter
Evaluating a Voltage Supervisor or Voltage Detector Device
VOLTAGE SUPERVISORS
TESTING THE VOLTAGE SUPERVISORS TRIP POINT OPERATION
8-PIN VOLTAGE SUPERVISOR
SOIC
TEST EQUIPMENT
Yes
Connect to:
V
V
V
V
V
DD
DD
OUT
OUT
OUT
, V
, V
DIP
Yes
(1)
(1)
(1)
SS
SS
This allows the voltage to the SOT23 Evaluation Board
to be varied so the device output can be monitored.
This is similar to a variable power supply, but allows pro-
grammability into the input signal that the device will be
subjected to. This also allows a particular waveform to
be repeated (such as a 60 Hz sine wave that varies from
1V to 5V).
Used to indicate the output state (low or high) of the
voltage supervisor/voltage detector.
Allows the device conditions and response to be evalu-
ated due to the ability to capture this information. This is
useful for faster signals and cases where small spikes
need to be detected.
Used to visually indicate the output state (low or high) of
the voltage supervisor/voltage detector. Ensure that the
current requirements of this LED can be supplied by the
device’s output pin.
Installation and Operation
MSOP
—
OUT
TSSOP
or RST pin will be dependent on the
—
Comment
Comment
DS51544A-page 15