DC-EM-KT Digi International, DC-EM-KT Datasheet - Page 89

• Manufacturer Part Number: DC-EM-KT
• Description: KIT INTEGRATION EM FOR S MODELS
• Manufacturer: Digi International
• Series: Digi Connect EM®r
• Type: MCU Moduler

Specifications of DC-EM-KT

• Contents: Module with plug-and-play firmware, Development Board, Documentation, CD, Cables and Power Supply
• For Use With/related Products: Digi Connect EM S Module
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 602-1003; DC-EM-01T-KT; DC-EM-02T-KT

UDP Settings
The UDP Settings are displayed only when the current port is configured with the UDP
Sockets or the Custom Profile. Not supported in Digi Connect WAN.
Enter the string 1 to 4 characters in the Match String field. Non-printable
characters can be entered as follows:
Check Strip: Match string before sending to strip the string from the data before
it is sent to the destination.
Send after the following number of idle milliseconds: Send the data after the
specified number of milliseconds has passed with no additional data received
on the serial port. This can be 1 to 65,535 milliseconds.
Send after the following number of bytes: Send the data after the specified
number of bytes has been received on the serial port. This can be 1 to 65,535
bytes.
Close connection after the following number of idle seconds: Enable to close an
idle connection. Use the Timeout field to enter the number of seconds that the
connection will be idle before it is closed. This can be 1 to 65000 seconds.
Close connection when DCD goes low: When selected, the connection will be
closed when the DCD (Data Carrier Detected) signal goes low.
Close connection when DSR goes low: When selected, the connection will be
closed when the DSR (Data Set Ready) signal goes low.
hexadecimal
values
tab
line feed
backslash
Character
C o n f i g u r i n g t h e D i g i C o n n e c t D e v i c e s
Sequence
Key
\xhh
\n
\t
\\
8 9