SUPERPRO 501S Xeltek, SUPERPRO 501S Datasheet - Page 86

• Manufacturer Part Number: SUPERPRO 501S
• Description: PROGRAMMER UNIVERSAL 48-PIN
• Manufacturer: Xeltek
• Series: SuperPro 501Sr
• Type: Universal, Stand Aloner

Specifications of SUPERPRO 501S

• Contents: Programmer with 48-Pin DIP Socket, AC Adapter, Software CD, USB Cable, Users Manual
• Ic Product Type: Programmer, Universal
• Ic Interface Type: USB
• No. Of Devices Supported: 22488
• Kit Contents: SuperPro 501S Programmer, AC Adapter, CD
• Rohs Compliant: Yes
• For Use With/related Products: E/EPROM, FLASH, PLD, Micros and more listed on Device Sheet, 21,000+ Devices Supported
• For Use With: 415-1029 - SOCKET ADAPTER FOR SDIP42415-1028 - SOCKET ADAPTER FOR TQFP32415-1027 - SOCKET ADAPTER FOR TSOP56415-1025 - SOCKET ADAPTER FOR SOIC20415-1024 - SOCKET ADAPTER FOR TSOP40415-1023 - SOCKET ADAPTER FOR SOP44415-1022 - SOCKET ADAPTER FOR TSOP56415-1019 - SOCKET ADAPTER FOR SOIC16/SOIC8415-1018 - SOCKET ADAPTER FOR SOIC28415-1015 - SOCKET ADAPTER FOR PLCC28415-1014 - SOCKET ADAPTER FOR PLCC20415-1013 - SOCKET ADAPTER FOR PLCC32415-1017 - SOCKET ADAPTER FOR PLCC44
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Other names: 415-1046; SP501S











Insertion Test Errors
The following error messages may occur during the Insertion Test.



Superpro
ceased.
Programmer not found: The programmer is not connected to the PC or it
is connected improperly. Check the connection. Refer to Chapter 2 System
Installation on page 13 for more information. 
Programmer not ready: Turn off the programmer power switch and turn it on
again after a few seconds. 
Programmer is running: The programmer hardware is operating. Wait until
the operation is finished. 
File open error: The open file operation failed. 
Out of Memory: The memory overflows. 
Production mode isnʹt available for this chip: Since the production mode is
dependent on the pin check, the chips without pin check function are not
applicable for production mode. 
Cancel production mode: Cancel the production mode. 
Too long file name: The file name is too long. 
User cancel: The system displays this message after you select Cancel on the
Status bar. 
Canʹt cancel!: The Cancel operation has failed. 
Not a project file: The file selected is not a project file. After the software is
updated, the software may not be able to identify a previously created file. You
will need to create the file again. 
No device in the socket.: The system did not detect a device in the socket.
Insert a chip. 
Find non‐connection or poor pin contact: The system detected poor pin
contact. Check the pin contact. If you find nothing wrong with the connection
of the noted pin(s) replace the chip with another in case the first chip is broken. 
The pin number refers to DIP chip’s pin number or the adapter’s pin number. 
Device inserted backwards or damaged.: Take the chip out, reverse it,
and insert it again properly. If the problem still exists, the chip may have
been damaged. 
®
5000 User’s Guide
86