ST7FLITE39M6TR STMicroelectronics, ST7FLITE39M6TR Datasheet - Page 86

• Manufacturer Part Number: ST7FLITE39M6TR
• Description: IC MCU 8BIT 8K FLASH 20SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE39M6TR

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: LINSCI, SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE3x
• Core: ST7
• Data Bus Width: 8 bit
• Development Tools By Supplier: ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• For Use With: 497-8403 - BOARD DEMO STCC08 AC SW DETECTOR497-6398 - BOARD EVAL ST7FLITE39/STM1403497-5858 - EVAL BOARD PLAYBACK ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Function Descriptions
Table 48. I2C_PutByte
Notes:
– The above function is for I2C Polling or I2C Interrupt driven mode.
– It is recommended to add a timeout protection when using this function.
86/235
Function Name
Function Prototype
Behaviour Description
Input Parameters
Output Parameters
Required Preconditions
Functions called
Postconditions
See also
I2C_PutByte
Void I2C_PutByte (unsigned char Tx_Data)
Transmits a single byte of data in I2C Polling or I2C Inter-
rupt driven mode.
Tx_Data
Data byte to be transmitted.
None
1. I2C_Load_Address must have been called (If I2C is
configured in master transmitter mode).
2. You must define I2C Polling or I2C interrupt driven
transmission mode in ST7lib_config.h.
3. You must enable interrupts in I2C interrupt driven
mode.
4. In I2C interrupt driven mode
I2C_IsTransmitCompleted must have been called to en-
sure that there are no pending requests.
5. In I2C Interrupt driven mode, I2C_IT_Function must
have been called in the Interrupt service routine.
None
I2C_IsTransmitCompleted can be called after this function
to get the transmission status.
None