ST7FLITE29F2M6TR STMicroelectronics, ST7FLITE29F2M6TR Datasheet - Page 89

• Manufacturer Part Number: ST7FLITE29F2M6TR
• Description: IC MCU 8BIT 8K FLASH 20-SOIC
• Manufacturer: STMicroelectronics
• Series: ST7r

Specifications of ST7FLITE29F2M6TR

• Core Processor: ST7
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 8KB (8K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 384 x 8
• Voltage - Supply (vcc/vdd): 2.4 V ~ 5.5 V
• Data Converters: A/D 7x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-SOIC (7.5mm Width)
• Processor Series: ST7FLITE2x
• Core: ST7
• Data Bus Width: 8 bit
• Data Ram Size: 384 B
• Interface Type: SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 15
• Number Of Timers: 3
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: ST7FLIT2-COS/COM, ST7FLITE-SK/RAIS, ST7MDT10-DVP3, ST7MDT10-EMU3, STX-RLINK
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 7 Channel / 13 bit, 7 Channel
• For Use With: 497-5858 - EVAL BOARD PLAYBACK ST7FLITE497-5049 - KIT STARTER RAISONANCE ST7FLITE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Table 51. I2C_PutString
Note: The above function is only for I2C Interrupt driven mode.
Caution:
– Take care not to access the string until transmission is complete.
– The data transmission will stop if any error occurs during transmission.
Function Name
Function Prototype
Behaviour Description
Input Parameters
Output Parameters
Required Preconditions
Functions called
Postconditions
See also
I2C_PutString
Void I2C_PutString (const unsigned char *PtrToString)
Starts transmission of a data string in I2C interrupt driven
mode from the user defined area.
*PtrToString
Start address of the user string.
None
1. I2C_Load_Address must have been called (If I2C is
configured in master transmitter mode).
2. You must define I2C interrupt driven mode in
ST7lib_config.h.
3. I2C_IsTransmitCompleted must have been called to en-
sure that there are no pending requests.
4. You must enable interrupt for this mode.
5. I2C_IT_Function must have been called in the Interrupt
service routine.
None
I2C_IsTransmitCompleted can be called after this function
to get the transmission status.
I2C_PutString (I2C Polling mode)
Function Descriptions
89/235