MC9S08DZ128CLF Freescale Semiconductor, MC9S08DZ128CLF Datasheet - Page 51

• Manufacturer Part Number: MC9S08DZ128CLF
• Description: MCU 8BIT 128K FLASH 48-LQFP
• Manufacturer: Freescale Semiconductor
• Series: HCS08r

Specifications of MC9S08DZ128CLF

• Core Processor: HCS08
• Core Size: 8-Bit
• Speed: 40MHz
• Connectivity: CAN, I²C, LIN, SCI, SPI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 39
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 16x12b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-LQFP
• Package: 48LQFP
• Family Name: HCS08
• Maximum Speed: 40 MHz
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 8 Bit
• Number Of Programmable I/os: 87
• Interface Type: CAN/I2C/SPI/UART
• On-chip Adc: 24-chx12-bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4.3
The registers in the MC9S08DZ128 Series are divided into these groups:
Direct-page registers can be accessed with efficient direct addressing mode instructions. Bit manipulation
instructions can be used to access any bit in any direct-page register.
user-accessible direct-page registers and control bits.
The direct page registers in
only the lower byte of the address. Because of this, the lower byte of the address in column one is shown
in bold text. In
Table
bit names to the right. Cells that are not associated with named bits are shaded. A shaded cell with a 0
indicates this unused bit always reads as a 0. Shaded cells with dashes indicate unused or reserved bit
locations that could read as 1s or 0s.
Freescale Semiconductor
•
•
•
4-3, and
Because the nonvolatile register locations are FLASH memory, they must be erased and
programmed like other FLASH memory locations.
Direct-page registers are located in the first 128 locations in the memory map; these are accessible
with efficient direct addressing mode instructions.
High-page registers are used much less often, so they are located above 0x1800 in the memory
map. This leaves more room in the direct page for more frequently used registers and RAM.
The nonvolatile register area consists of a block of 16 locations in FLASH memory at
0xFFB0–0xFFBF. Nonvolatile register locations include:
— NVPROT and NVOPT are loaded into working registers at reset
— An 8-byte backdoor comparison key that optionally allows a user to gain controlled access to
Register Addresses and Bit Assignments
secure memory
Table
Table 4-3
4-5, the register names in column two are shown in bold to set them apart from the
and
Table 4-2
Table
MC9S08DZ128 Series Data Sheet, Rev. 1
4-5, the whole address in column one is shown in bold. In
can use the more efficient direct addressing mode, which requires
Table 4-2
is a summary of all
Chapter 4 Memory
Table
4-2,
51