HD64F3694FTV Renesas Electronics America, HD64F3694FTV Datasheet - Page 89

• Manufacturer Part Number: HD64F3694FTV
• Description: IC H8/3694F MCU FLASH 48-QFN
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3694FTV

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, SCI
• Peripherals: PWM, WDT
• Number Of I /o: 29
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 48-QFN
• For Use With: R0K436079S000BE - KIT DEV FOR H8/36079 W/COMPILER
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

2. When multiple interrupt requests are generated, the interrupt controller requests to the CPU for
3. The CPU accepts the NMI and address break without depending on the I bit value. Other
4. If the CPU accepts the interrupt after processing of the current instruction is completed,
5. Then, the I bit of CCR is set to 1, masking further interrupts excluding the NMI and address
6. Next, the CPU generates the vector address corresponding to the accepted interrupt, and
Figure 3.3 shows a typical interrupt sequence where the program area is in the on-chip ROM and
the stack area is in the on-chip RAM.
the interrupt handling with the highest priority at that time according to table 3.1. Other
interrupt requests are held pending.
interrupt requests are accepted, if the I bit is cleared to 0 in CCR; if the I bit is set to 1, the
interrupt request is held pending.
interrupt exception handling will begin. First, both PC and CCR are pushed onto the stack. The
state of the stack at this time is shown in figure 3.2. The PC value pushed onto the stack is the
address of the first instruction to be executed upon return from interrupt handling.
break. Upon return from interrupt handling, the values of I bit and other bits in CCR will be
restored and returned to the values prior to the start of interrupt exception handling.
transfers the address to PC as a start address of the interrupt handling-routine. Then a program
starts executing from the address indicated in PC.
Rev.5.00 Nov. 02, 2005 Page 59 of 418
Section 3 Exception Handling
REJ09B0028-0500