DF2339VFC25 Renesas Electronics America, DF2339VFC25 Datasheet - Page 166

• Manufacturer Part Number: DF2339VFC25
• Description: IC H8S MCU FLASH 384K 144QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2339VFC25

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 106
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2339VFC25; HD64F2339VFC25

Section 2 Instruction Descriptions
2.2.41
MOVTPE (MOVe To Peripheral with E clock)
Operation
Rs
Synchronized with E clock
Assembly-Language Format
MOVTPE Rs, @aa:16
Operand Size
Byte
Description
This instruction transfers the contents of a general register Rs (source operand) to a destination
location specified by a 16-bit absolute address in synchronization with an E clock, tests the
transferred data, and sets condition-code flags according to the result.
Note: Avoid using this instruction in microcontrollers without an E clock output pin, or in
Available Registers
Rs: R0L to R7L, R0H to R7H
Operand Format and Number of States Required for Execution
Note: * For details, refer to the relevant microcontroller hardware manual.
Notes
1. This instruction cannot be used with addressing modes other than the above, and cannot
2. The number of states required for execution is variable. For details, refer to the relevant
Rev. 4.00 Feb 24, 2006 page 150 of 322
REJ09B0139-0400
Absolute address
Addressing
transfer word data or longword data.
microcontroller hardware manual.
Mode
(EAd)
single-chip mode.
MOVTPE
Mnemonic
MOVTPE
Rs, @aa:16
Operands
1st byte
6
A
Condition Code
H: Previous value remains unchanged.
N: Set to 1 if the transferred data is negative;
Z: Set to 1 if the transferred data is zero;
V: Always cleared to 0.
C: Previous value remains unchanged.
2nd byte
C
Instruction Format
otherwise cleared to 0.
otherwise cleared to 0.
—
I
rs
UI H
—
—
3rd byte
—
U
Move Data with E Clock
abs
N
4th byte
Z
V
0
—
States
No. of
C
*