MC68HC711E9CFN3 Freescale Semiconductor, MC68HC711E9CFN3 Datasheet - Page 187

• Manufacturer Part Number: MC68HC711E9CFN3
• Description: IC MCU 3MHZ 12K OTP 52-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC711E9CFN3

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 3MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 38
• Program Memory Size: 12KB (12K x 8)
• Program Memory Type: OTP
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 52-PLCC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

9.5.1 Timer Output Compare Registers
M68HC11E Family — Rev. 3.2
MOTOROLA
appropriate output either high or low, depending on the polarity of the
pulse being produced. After a match occurs, the output compare register
is reprogrammed to change the output pin back to its inactive level at the
next match. A value representing the width of the pulse is added to the
original value, and then written to the output compare register. Because
the pin state changes occur at specific values of the free-running
counter, the pulse width can be controlled accurately at the resolution of
the free-running counter, independent of software latencies. To generate
an output signal of a specific frequency and duty cycle, repeat this
pulse-generating procedure.
The five 16-bit read/write output compare registers are: TOC1, TOC2,
TOC3, and TOC4, and the TI4/O5. TI4/O5 functions under software
control as either IC4 or OC5. Each of the OC registers is set to $FFFF
on reset. A value written to an OC register is compared to the
free-running counter value during each E-clock cycle. If a match is
found, the particular output compare flag is set in timer interrupt flag
register 1 (TFLG1). If that particular interrupt is enabled in the timer
interrupt mask register 1 (TMSK1), an interrupt is generated. In addition
to an interrupt, a specified action can be initiated at one or more timer
output pins. For OC[5:2], the pin action is controlled by pairs of bits (OMx
and OLx) in the TCTL1 register. The output action is taken on each
successful compare, regardless of whether or not the OCxF flag in the
TFLG1 register was previously cleared.
OC1 is different from the other output compares in that a successful OC1
compare can affect any or all five of the OC pins. The OC1 output action
taken when a match is found is controlled by two 8-bit registers with
three bits unimplemented: the output compare 1 mask register, OC1M,
and the output compare 1 data register, OC1D. OC1M specifies which
port A outputs are to be used, and OC1D specifies what data is placed
on these port pins.
All output compare registers are 16-bit read-write. Each is initialized to
$FFFF at reset. If an output compare register is not used for an output
compare function, it can be used as a storage location. A write to the
Timing System
Output Compare
Timing System
Technical Data
187