OP270EZ Analog Devices Inc, OP270EZ Datasheet - Page 5

• Manufacturer Part Number: OP270EZ
• Description: IC OPAMP GP 5MHZ DUAL PREC 8CDIP
• Manufacturer: Analog Devices Inc

Specifications of OP270EZ

• Slew Rate: 2.4 V/µs
• Rohs Status: RoHS non-compliant
• Amplifier Type: General Purpose
• Number Of Circuits: 2
• Gain Bandwidth Product: 5MHz
• Current - Input Bias: 5nA
• Voltage - Input Offset: 10µV
• Current - Supply: 4mA
• Voltage - Supply, Single/dual (±): ±4.5 V ~ 18 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Through Hole
• Package / Case: 8-CDIP (0.300", 7.62mm)
• Op Amp Type: Low Noise
• No. Of Amplifiers: 2
• Bandwidth: 5MHz
• Supply Voltage Range: ± 4.5V To ± 18V
• Amplifier Case Style: DIP
• No. Of Pins: 8
• Channel Separation: 175
• Common Mode Rejection Ratio: 125
• Current, Input Bias: 5 nA
• Current, Input Offset: 1 nA
• Current, Supply: 4 mA
• Impedance, Thermal: 12 °C/W
• Number Of Amplifiers: Dual
• Package Type: CDIP-8
• Resistance, Input: 0.4 Megohms (Differential), 20 Gigaohms (Common-Mode)
• Temperature, Operating, Range: -40 to +85 °C
• Voltage, Gain: 2300 V/mV
• Voltage, Input: ±12.5 V
• Voltage, Noise: 3.6 nV/sqrt Hz
• Voltage, Offset: 10 μV
• Voltage, Output, High: +13.5 V
• Voltage, Output, Low: -13.5 V
• Voltage, Supply: ±15 V
• Output Type: -
• Current - Output / Channel: -
• -3db Bandwidth: -
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

ABSOLUTE MAXIMUM RATINGS
Table 3.
Parameter
Supply Voltage
Differential Input Voltage
Differential Input Current
Input Voltage
Output Short-Circuit Duration
Storage Temperature Range
Lead Temperature Range (Soldering, 60 sec)
Junction Temperature (T
Operating Temperature Range
1
The OP270 inputs are protected by back-to-back diodes. To achieve low noise
performance, current-limiting resistors are not used. If the differential voltage
exceeds +10 V, the input current should be limited to ±25 mA.
J
)
1
1
Rating
18 V
1.0 V
±25 mA
Supply voltage
Continuous
−65°C to +150°C
300°C
−65°C to +150°C
−40°C to +85°C
Rev. E | Page 5 of 20
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
For military processed devices, refer to the Standard Micro-
circuit Drawing (SMD) available at the Defense Logistics
Agency website.
Table 4. Analog Devices Equivalent to SMD
SMD Part Number
5962-8872101PA
ESD CAUTION
Analog Devices Equivalent
OP270AZMDA
OP270