MCP608T-I/ST Microchip Technology, MCP608T-I/ST Datasheet - Page 15

• Manufacturer Part Number: MCP608T-I/ST
• Description: IC OPAMP 2.5V R-R W/CS 8TSSOP
• Manufacturer: Microchip Technology

Specifications of MCP608T-I/ST

• Slew Rate: 0.08 V/µs
• Amplifier Type: General Purpose
• Number Of Circuits: 1
• Output Type: Rail-to-Rail
• Gain Bandwidth Product: 155kHz
• Current - Input Bias: 1pA
• Voltage - Input Offset: 250µV
• Current - Supply: 18.7µA
• Current - Output / Channel: 17mA
• Voltage - Supply, Single/dual (±): 2.5 V ~ 6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-TSSOP
• Op Amp Type: Low Power
• No. Of Amplifiers: 1
• Bandwidth: 155kHz
• Supply Voltage Range: 2.5V To 5.5V
• Amplifier Case Style: TSSOP
• No. Of Pins: 8
• Number Of Channels: 1
• Voltage Gain Db: 121 dB
• Common Mode Rejection Ratio (min): 75 dB
• Input Offset Voltage: 0.25 mV
• Operating Supply Voltage: 3 V, 5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• -3db Bandwidth: -
• Lead Free Status / Rohs Status: Details

5.0
Microchip provides the basic design tools needed for
the MCP606/7/8/9 family of op amps.
5.1
The latest SPICE macro model for the MCP606/7/8/9
op
www.microchip.com. This model is intended to be an
initial design tool that works well in the op amp’s linear
region of operation at room temperature. See the
model file for information on its capabilities.
Bench testing is a very important part of any design and
cannot be replaced with simulations. Also, simulation
results using this macro model need to be validated by
comparing them to the data sheet specifications and
characteristic curves.
5.2
The FilterLab software is an innovative tool that
simplifies analog active-filter (using op amps) design. It
is available free of charge from our web site at
www.microchip.com. The FilterLab software tool
provides full schematic diagrams of the filter circuit with
component values. It also outputs the filter circuit in
SPICE format, which can be used with the macro
model to simulate actual filter performance.
© 2005 Microchip Technology Inc.
amps
DESIGN TOOLS
SPICE Macro Model
FilterLab
is
available
®
Software
on
our
web
site
at
MCP606/7/8/9
DS11177D-page 15