ZU-M2242S3R2 Panasonic - ATG, ZU-M2242S3R2 Datasheet - Page 8

• Manufacturer Part Number: ZU-M2242S3R2
• Description: CARD READER HALF INSERT RS-232C
• Manufacturer: Panasonic - ATG

Specifications of ZU-M2242S3R2

• Card Reader Type: Magnetic, Push/Pull
• Interface: RS232C
• Card Read/write Type And Tracks: Magnetic - Read Tracks 1,2
• Card Reading Direction: Insertion/Ejection
• Card Standard: ISO 1, ISO 2
• Card Speed: 10 ~ 120 cm/s
• Supply Voltage: 5V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: PCR225

8.3 UCIMAG Status Commands
8.4 UCIMAG Track Data Commands
:Nb
:SR - Send reader status, its configuration
:CA
:TA
:Tt
:ST
:V
Where:
if AutoNotify = 1 and AutoSend = 0, UCIMAG will send the message “Track Read” as soon as
the card has been inserted. The user can then poll the data with :Tn command.
Returns: SR:ABCI.scnde.xyz.t.<sh><sl><CR><LF>
Returns: ST:dsercc.dsercc.dsercc.<sh><sl><CR><LF>
Where:
Returns: “ Panasonic MIECOA UCI-MAG vx.xx Copyright xxxx”<CR><LF>
- Auto notify bit, if b=0 disable, if b=1 enable
- Clear All tracks
- Transmit All tracks (1,2,3)
- Transmit track ‘t’ data buffer in ASCII
- Send track status
- Send Firmware Version
A=CardLoad1 signal = 0 or 1
B=CardLoad2 signal = 0 or 1
C=CardLoad3 signal = 0 or 1
I=CardInserted signal = 0 or 1
s=AutoSend configuration bit = 0 or 1
c=AutoClear configuration bit = 0 or 1
n=AutoNotify configuration bit = 0 or 1
d=direction configuration bit = 0 or 1 (1 = reverse)
e=UseStartEnd configuration bit = 0 or 1
x=Track 1 enable bit = 0 or 1 (1=enabled)
y=Track 2 enable bit = 0 or 1 (1=enabled)
z=Track 3 enable bit = 0 or 1 (1=enabled)
t=Reader Type character
d= data was detected on track
s= start character was detected
e = end character was detected
r = LRC check was passed
cc = two characters representing the hex value of byte count of track
first set of “dsercc” is for track 1, second set is for track 2, and third set is for track 3
same as sending :T1, :T2, :T3 in sequence
note: track data will only be send if the track enable bit for that particular track is set
where t = 1,2, or 3 for the track number
- 5 -