129-0701-302 Emerson Network Power, 129-0701-302 Datasheet - Page 235

• Manufacturer Part Number: 129-0701-302
• Description: CONN JACK TEST SHIELD RIGHT ANGL
• Manufacturer: Emerson Network Power
• Type: Tip Jackr

Specifications of 129-0701-302

• Gender: Female
• Plug/mating Plug Diameter: Standard
• Mounting Type: Through Hole, Horizontal
• Termination: Solder
• Insulation: Non-Insulated
• Contact Finish: Gold
• Contact Material: Beryllium Copper
• Body Material: TFE Fluorocarbon
• Operating Temperature: -65°C ~ 85°C
• Color: Silver
• Contact Plating: Gold
• Equipment Type: Shielded Test Jack
• Voltage Rating: 2000 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Color: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 1290701302; J571

SMA Clamp Type Right Angle
Plugs for Flexible Cable
Connectivity Solutions
Tel: [phone]
RG-316/U, 161,
RG-55/U, 142,
•
RG-178/U,
RG-58/U,
Fax: [phone]
174, 188
141, 303
233, 400
GROUP
CABLE
196
Assembly Instructions
142-0202-101
142-0202-106
142-0203-101
142-0203-106
142-0207-101
142-0207-106
142-0207-101
142-0207-106
PART
•
NO.
1. Identify connector parts. (4 piece parts)
2. Strip cable to dimensions shown. Do not nick braid
3. Flare braid and slide cable into body making certain
4. Solder center conductor to contact through the rear
www.EmersonNetworkPower.com/connectivity
or center conductor. A wire stripper of correct size is
recommended for this step. Twist stranded center
conductor into tight bundle and tin (optional). Slide
clamp nut and clamp cone onto cable as shown.
Clamp cone must be oriented as shown for each size
of cable. The RG-58/142 clamp cone slides over braid
and against jacket.
that the cable insulation bottoms on center contact.
Stepped down diameter of stem must slide under
braid and jacket. Arrange braid uniformly around
crimp stem. Slide clamp nut against clamp cone and
braid and tighten to 10 in.-lb. torque.
access port. Use a minimum amount of solder for
a full fillet joint. .020 (0.51) diameter solder is rec-
ommended. Place expansion cap in access port and
seat with .187 (4.75) diameter flat punch.
INCHES (MILLIMETERS) • CUSTOMER DRAWINGS AVAILABLE ON REQUEST
.395 (10.03)
.395 (10.03)
.420 (10.67)
.420 (10.67)
.280 (7.11)
.280 (7.11)
.280 (7.11)
.280 (7.11)
“A”
.053 (1.35)
.053 (1.35)
.053 (1.35)
.053 (1.35)
.160 (4.06)
.160 (4.06)
.180 (4.57)
.180 (4.57)
“B”
.085 (2.16)
.085 (2.16)
.085 (2.16)
.085 (2.16)
None
None
None
None
“C”
235