DSP56321VF220 Freescale Semiconductor, DSP56321VF220 Datasheet - Page 7

• Manufacturer Part Number: DSP56321VF220
• Description: IC DSP 24BIT 220MHZ 196-BGA
• Manufacturer: Freescale Semiconductor
• Series: DSP563xxr
• Type: Fixed Pointr

Specifications of DSP56321VF220

• Interface: Host Interface, SSI, SCI
• Clock Rate: 220MHz
• Non-volatile Memory: ROM (576 B)
• On-chip Ram: 576kB
• Voltage - I/o: 3.30V
• Voltage - Core: 1.60V
• Operating Temperature: -40°C ~ 100°C
• Mounting Type: *
• Package / Case: 196-MAPBGA
• Device Core Size: 24b
• Format: Fixed Point
• Clock Freq (max): 220MHz
• Mips: 220
• Device Input Clock Speed: 220MHz
• Ram Size: 576KB
• Operating Supply Voltage (typ): 1.6/3.3V
• Operating Supply Voltage (min): 1.5/3/3/3/3/3/3V
• Operating Temp Range: -40C to 100C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 196
• Package Type: MA-BGA
• Package: 196MA-BGA
• Numeric And Arithmetic Format: Fixed-Point
• Maximum Speed: 220 MHz
• Device Million Instructions Per Second: 220 MIPS
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Signals/Connections
The DSP56321 input and output signals are organized into functional groups as shown in Table 1-1. Figure 1-1
diagrams the DSP56321 signals by functional group. The remainder of this chapter describes the signal pins in
each functional group.
Note: This chapter refers to a number of configuration registers used to select individual multiplexed signal
Freescale Semiconductor
Power (V
Ground (GND)
Clock
Address bus
Data bus
Bus control
Interrupt and mode control
Host interface (HI08)
Enhanced synchronous serial interface (ESSI)
Serial communication interface (SCI)
Timer
OnCE/JTAG Port
Notes:
functionality. See the DSP56321 Reference Manual for details on these configuration registers.
CC
1.
2.
3.
4.
5.
)
Port A signals define the external memory interface port, including the external address bus, data bus, and control signals.
Port B signals are the HI08 port signals multiplexed with the GPIO signals.
Port C and D signals are the two ESSI port signals multiplexed with the GPIO signals.
Port E signals are the SCI port signals multiplexed with the GPIO signals.
Eight signal lines are not connected internally. These are designated as no connect (NC) in the package description (see
Chapter 3). There are also two reserved lines.
Table 1-1.
Functional Group
DSP56321 Technical Data, Rev. 11
DSP56321 Functional Signal Groupings
Ports C and D
Port A
Port B
Port E
1
2
4
3
Number of
Signals
20
66
18
24
10
16
12
2
6
3
3
6
1
1-1