EM35X-BBRD Ember, EM35X-BBRD Datasheet - Page 134

• Manufacturer Part Number: EM35X-BBRD
• Description: EM35X BREAKOUT BOARD
• Manufacturer: Ember

Specifications of EM35X-BBRD

• Frequency: 2.4GHz
• For Use With/related Products: EM35x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 636-1013

For example, to configure the up-counter to count in response to a rising edge on the TI2 input, use the
following procedure:
When a rising edge occurs on TI2, the counter counts once and the INT_TIMTIF flag is set. The delay between
the rising edge on TI2 and the actual clock of the counter is due to the resynchronization circuit on the TI2
input. The relationship between rising edges on TI2 and the resulting counter clocks is shown in Figure 9-14.
9.3.3.3
This mode is selected by writing TIM_ECE = 1 in the TIMx_SMCR register. The counter can count at each rising
or falling edge on the external trigger input ETR.
The TIM_EXTRIGSEL bits in the TIMx_OR register select a clock signal that drives ETR, as shown in Table 9-2.
Configure channel 2 to detect rising edges on the TI2 input: Write TIM_CC2S = 01 in the TIMx_CCMR1
register.
Configure the input filter duration: Write the TIM_IC2F bits in the TIMx_CCMR1 register (if no filter is
needed, keep TIM_IC2F = 0000).
Note: The capture prescaler is not used for triggering, so it does not need to be configured.
Select rising edge polarity: Write TIM_CC2P = 0 in the TIMx_CCER register.
Configure the timer in external clock mode 1: Write TIM_SMS = 111 in the TIMx_SMCR register.
Select TI2 as the input source: Write TIM_TS = 110 in the TIMx_SMCR register.
Enable the counter: Write TIM_CEN = 1 in the TIMx_CR1 register.
External Clock Source Mode 2
Figure 9-14. Control Circuit in External Clock Mode 1
Figure 9-13. TI2 External Clock Connection Example
Final
9-10
120-035X-000G