XBP09-DMDK Digi International, XBP09-DMDK Datasheet - Page 5

• Manufacturer Part Number: XBP09-DMDK
• Description: KIT STARTER PROMESH XBEE PRO
• Manufacturer: Digi International
• Series: XBEE-PRO™r
• Type: Transceiver, XBeePror

Specifications of XBP09-DMDK

• Frequency: 900MHz
• Wireless Frequency: 900 MHz
• Interface Type: RS-232, USB, UART
• Modulation: FHSS
• Security: 128 bit AES
• Operating Voltage: 3.3 V
• Output Power: 50 mW
• Antenna: RPSMA
• For Use With/related Products: Xbee-PRO Modules
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 602-1130

CONFIGURE SLEEPING MODULES
The XBee’s can be configured quickly and easily for synchronous sleep. Using the X-CTU
software downloaded earlier, you can set up this simple example illustrating the XBee’s sleeping
capabilities.
1. Launch X-CTU and select the corresponding COM Port.
2. Change the settings under the PC Settings tab to Baud Rate: 9600, Flow Control: HARDWARE,
3.
4.
5.
6.
7.
8.
9.
Once the radio has been "Read", a list of
con gurable parameters will be displayed.
The parameters listed in green are still set
to default. Those in blue have been
changed. The parameters shown in black
are listed for informational purposes and
cannot be changed.
Data Bits: 8, Parity: NONE, and Stop Bits: 1.
Click on the Modem Configuration tab.
Click "Read".
Scroll down until you find the "Sleep Commands" section.
Set the Sleep Options (SO) parameter to 1 on one of your radios. This sets it to be the Preferred
Sleep Coordinator. The preferred sleep coordinator controls the synchronization of the network.
This radio sends out a pulse to tell the others in the network when to sleep.
Set the Sleep Time (SP) parameter to the hexidecimal value 3E8 (10 seconds).
Set the Sleep Mode (SM) to 4-CYCLIC.
Then, click “Write”.
Figure 4. Radio Con guration