XBP09-DMDK Digi International, XBP09-DMDK Datasheet - Page 8

• Manufacturer Part Number: XBP09-DMDK
• Description: KIT STARTER PROMESH XBEE PRO
• Manufacturer: Digi International
• Series: XBEE-PRO™r
• Type: Transceiver, XBeePror

Specifications of XBP09-DMDK

• Frequency: 900MHz
• Wireless Frequency: 900 MHz
• Interface Type: RS-232, USB, UART
• Modulation: FHSS
• Security: 128 bit AES
• Operating Voltage: 3.3 V
• Output Power: 50 mW
• Antenna: RPSMA
• For Use With/related Products: Xbee-PRO Modules
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 602-1130

CHANGE FIRMWARE VERSION
Toll-free phone U.S.A. & Canada: [phone]
Live chat: www.digi.com
Online support: http://www.digi.com/support/eservice/login.jsp
These modules can also be setup for multipoint communications. In some cases, a multipoint solution
may be a better option. Point to multipoint is better for networks not needing routing capabilities.
This topology also has more predictable timing and faster throughput. If you wish to try multipoint
mode, you can simply load different firmware on your XBees.
X-CTU is used to load different firmware on the radios.
1. Launch X-CTU and select the corresponding COM Port.
2. Set the PC settings back to default. (Baud Rate: 9600, Flow Control: NONE, Data Bits: 8, Parity:
3. Click on the Modem Configuration tab.
4. Select the modem type. The point to multipoint firmware for the XBee PRO 900 modules is
5. Choose the function set and firmware version desired.
6. Click the “Show Defaults” button. This helps to avoid out of range errors since some parameters
7. Check the “Always update firmware” box.
8. Click “Write”.
NONE, Stop: Bits 1)
XBP09-DP. The XBee 802.15.4 modules use XB24 firmware for point to multipoint communication
and the XBee PRO 802.15.4 modules use XBP24 firmware. [Figure 7]
have different limits based on the firmware type.
If you have further questions, please contact technical support.
(http://www.digi.com/support/eservice/login.jsp)
The function set that automatically loads
is the standard point to multipoint one.
The default rmware loaded is the newest
version in X-CTU's database.
Figure 7. Point-to-Multipoint Firmware
Worldwide: [phone]