XB24-BUIT-004 Digi International/Maxstream, XB24-BUIT-004 Datasheet - Page 35
![no-image](/images/no-image-200.jpg)
XB24-BUIT-004
Manufacturer Part Number
XB24-BUIT-004
Description
MODULE 802.15.4 SER 2 U.FL CONN
Manufacturer
Digi International/Maxstream
Series
XBee™r
Datasheet
1.XB24-BPDK.pdf
(91 pages)
Specifications of XB24-BUIT-004
Frequency
2.4GHz
Data Rate - Maximum
250kbps
Modulation Or Protocol
802.15.4
Applications
Home/Building Automation, Industrial Control, ZigBee™
Power - Output
2 mW (3 dBm)
Sensitivity
-96dBm
Voltage - Supply
2.1 V ~ 3.6 V
Current - Receiving
38mA
Current - Transmitting
35mA
Data Interface
PCB, Through Hole
Antenna Connector
U.FL
Operating Temperature
-40°C ~ 85°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Memory Size
-
XBee ZNet 2.5/XBee‐PRO ZNet 2.5 ZigBee OEM RF Modules v1.x4x
4.3. Sleeping End Devices
4.3.1. End Device Operation
The following cluster IDs are supported on the data endpoint (0xE8):
Table 4‐05. Supported Cluster IDs on the Data Endpoint
XBee ZNet 2.5 modules support sleep mode operation in the Router / End Device firmware. Sleep
modes allow a ZigBee end device to enter a low power mode when idle and wake as needed to
transmit or receive data.
End devices must join to a router or coordinator to become part of a network. When the join
occurs, the end device becomes the child of the router or coordinator that allowed the join, and
the device that allowed the join becomes the end device’s parent.
A router or coordinator can only allow up to 8 end devices to join to it. Once 8 end devices have
joined to a parent, no additional end devices can join until a network reset condition occurs on the
parent.
ZigBee end devices rely on a parent (router or coordinator) to remain awake and receive any data
packets destined for the end device. When the end device wakes from sleep, it sends a
transmission (poll request) to its parent asking if the parent has received any RF data destined for
the end device. The parent, upon receipt of the poll request, will send an RF response and the
buffered data (if present).
If the parent has no data for the end device, the end device may return to sleep, depending on its
sleep mode configuration settings. The following figure demonstrates how the end device uses
polling to receive RF data through its parent.
Cluster ID
© 2008 Digi International, Inc.
0x11
0x12
0x92
0x94
0x95
XBee sensor sample data
Transparent serial data
Serial loopback data
Node identification
IO sample data
Name
IO samples are transmitted to a
Data received on this cluster ID
commissioning button sends a
broadcast transmission to this
transmits sensor readings on
This is the default cluster ID
used to transmit serial data.
is transmitted back to the
remote on this cluster ID.
An XBee sensor device
A single press on the
Description
this cluster ID.
cluster ID.
sender.
34