XB24-BUIT-004 Digi International/Maxstream, XB24-BUIT-004 Datasheet - Page 51
![no-image](/images/no-image-200.jpg)
XB24-BUIT-004
Manufacturer Part Number
XB24-BUIT-004
Description
MODULE 802.15.4 SER 2 U.FL CONN
Manufacturer
Digi International/Maxstream
Series
XBee™r
Datasheet
1.XB24-BPDK.pdf
(91 pages)
Specifications of XB24-BUIT-004
Frequency
2.4GHz
Data Rate - Maximum
250kbps
Modulation Or Protocol
802.15.4
Applications
Home/Building Automation, Industrial Control, ZigBee™
Power - Output
2 mW (3 dBm)
Sensitivity
-96dBm
Voltage - Supply
2.1 V ~ 3.6 V
Current - Receiving
38mA
Current - Transmitting
35mA
Data Interface
PCB, Through Hole
Antenna Connector
U.FL
Operating Temperature
-40°C ~ 85°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Memory Size
-
XBee ZNet 2.5/XBee‐PRO ZNet 2.5 ZigBee OEM RF Modules v1.x4x
A pushbutton and an LED can be connected to module pins 20 and 15 respectively to
support the commissioning pushbutton and associate LED functionalities.
5.4.1. Commissioning Pushbutton
Figure 5‐020. Commissioning Pushbutton and Associate LED Functionalities
The commissioning pushbutton definitions provide a variety of simple functions to aid in deploying
devices in a network. The commissioning button functionality on pin 20 is enabled by setting the
D0 command to 1 (enabled by default)..
Table 5‐014.
© 2008 Digi International, Inc.
Presses
Button
1
2
4
If module is joined to a network
XBee
• Wakes an end device for
• Sends a node identifica-
• Sends a broadcast trans-
• Causes the device to leave
• Issues ATRE to restore
• The device attempts to
30 seconds
tion broadcast transmis-
sion
mission to enable joining
on the coordinator and all
devices in the network for
1 minute. (If joining is
permanently enabled on a
device (NJ = 0xFF), this
action has no effect on
that device.)
the PAN.
module parameters to
default values, including
ID and SC.
join a network based on
its ID and SC settings.
20
15
Push button
R
If module is not joined to a net-
• Wakes an end device for
• Blinks a numeric error
• N/A
• Issues ATRE to restore
• The device attempts to
30 seconds
code on the Associate pin
indicating the cause of
join failure (see section
6.4.2).
module parameters to
default values, including
ID and SC.
join a network based on
its ID and SC settings.
Associate
LED
work
50