CLRC63201T/0FE,112 NXP Semiconductors, CLRC63201T/0FE,112 Datasheet - Page 91

• Manufacturer Part Number: CLRC63201T/0FE,112
• Description: IC I.CODE HS READER 32-SOIC
• Manufacturer: NXP Semiconductors
• Series: I-Coder

Specifications of CLRC63201T/0FE,112

• Rf Type: Read Only
• Frequency: 13.56MHz
• Features: ISO14443-A, ISO14443-B, ISO15693, ISO18000-3
• Package / Case: 32-SOIC (0.300", 7.50mm Width)
• Product: RFID Readers
• Operating Temperature Range: - 25 C to + 85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-2199-5; 935269690112; CLRC632; CLRC63201TD

NXP Semiconductors
CLRC632_35
Product data sheet
PUBLIC
11.3.3 Transceive command 1Eh
11.3.4 Label communication states
Table 147. Transceive command 1Eh
The Transceive command first executes the Transmit command (see
page
to be transmitted is sent using the FIFO buffer and all received data is written to the FIFO
buffer. The Transceive command can be started only by the microprocessor.
Remark: To adjust the timing relationship between transmitting and receiving, use the
RxWait register. This enables the time delay from the last bit transmitted until the receiver
is activated to be defined. The BitPhase register is used to set-up the phase-shift between
the transmitter and the receiver clock.
The status of the transmitter and receiver state machine can be read from the
PrimaryStatus register ModemState[2:0] bits. The assignment of ModemState[2:0] to the
internal action is shown in
Table 148. ModemState values
Command
Transceive
ModemState
[2:0]
000
001
010
011
100
101
110
111
79) and then starts the Receive command (see
Value
1Eh
Name
Idle
TxSOF
TxData
TxEOF
GoToRx1
GoToRx2
PrepareRx
AwaitingRx
Receiving
Rev. 3.5 — 10 November 2009
Action
transmits data from FIFO buffer to the
label and then activates the receiver
Table
Multiple protocol contactless reader IC (MIFARE/I-CODE1)
Description
transmitter and/or receiver are not operating
transmitting the start of frame pattern
transmitting data from the FIFO buffer (or CRC check bits)
transmitting the end of frame pattern
intermediate state passed, when receiver starts
intermediate state passed, when receiver finishes
waiting until the RxWait register wait time has elapsed
receiver activated; awaiting an input signal on pin RX
receiving data
073935
148.
Section 11.2.2 on page
Arguments
and data
data stream
Section 11.2.1 on
CLRC632
© NXP B.V. 2009. All rights reserved.
Returned
data
data stream
82). All data
91 of 126