LM2512SM/NOPB National Semiconductor, LM2512SM/NOPB Datasheet - Page 10

• Manufacturer Part Number: LM2512SM/NOPB
• Description: IC SERIALIZER 24BIT RGB 49-UFBGA
• Manufacturer: National Semiconductor
• Series: LMr

Specifications of LM2512SM/NOPB

• Function: Serializer
• Data Rate: 468Mbps
• Input Type: LVCMOS
• Output Type: LVCMOS
• Number Of Inputs: 21
• Number Of Outputs: 3
• Voltage - Supply: 1.6 V ~ 3 V
• Operating Temperature: -30°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 49-UFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: LM2512SM

www.national.com
OFF PHASE
In the OFF phase, MPL transmitters are turned off with zero
current flowing on the MC and MDn lines.
the transition of the MPL bus into the OFF phase. If an MPL
line is driven to a logical Low (high current) when the OFF
phase is entered it may temporarily pass through as a logical
High (low current) before reaching the zero line current state.
The link may be powered down by asserting both the SER’s
and DES’s PD* input pins (Low) or by stopping the PCLK
(DES dependant). This causes the devices to immediately put
the link to the OFF Phase and internally enter a low power
state.
FIGURE 10. Bus Power Down Timing
201728 Version 5 Revision 1
Figure 10
FIGURE 9. MPL Power Up Timing
20172806
shows
Print Date/Time: 2010/01/20 21:11:52
10
RGB VIDEO INTERFACE
The LM2512 is transparent to data format and control signal
timing. Each PCLK, RGB inputs, HS, VS and DE are sampled
on the rising edge of the PCLK. A PCLK by PCLK represen-
tation of these signals is duplicated on the opposite device
after being transferred across the MPL Level-0 interface.
The LM2512 can accommodate a wide range of display for-
mats. QVGA to VGA can be supported within the 2MHz to 20
MHz PCLK input range.
The 24-bit RGB (R0-7, G0-7, B0-7) color information is
dithered to 18 bits then serialized, followed by the control bits
VS (VSYNC), HS (HSYNC), DE (Data Enable) and PE (Odd
Parity) and Frame Sequence (F[1:0]) bits.
The default configuration is for 3 MD lanes plus the MC. Via
the SPI Interface, the Serializer can be configured for a 2 MD
Lane configuration.
When transporting color depth below 24-bit, the 24-bit proto-
col can be used by offsetting the color data. The LSBs of the
RGB are not used and data is offset toward the upper (MSB)
end of the bit fields. Unused inputs should be tied off.
At a maximum PCLK of 20 MHz (3MDs), a 80MHz MC clock
is generated. The data lane rate uses both clock edges, thus
160Mbps (raw) are sent per MD lane.
20172861