S29GL128P11TFI020 Spansion Inc., S29GL128P11TFI020 Datasheet - Page 64
![Flash 3V 128Mb Mirrorbit lowest address110ns](/photos/16/11/161172/s29gl512p11tfi020_sml.jpg)
S29GL128P11TFI020
Manufacturer Part Number
S29GL128P11TFI020
Description
Flash 3V 128Mb Mirrorbit lowest address110ns
Manufacturer
Spansion Inc.
Specifications of S29GL128P11TFI020
Memory Type
NOR
Memory Size
128 Mbit
Access Time
110 ns
Data Bus Width
8 bit, 16 bit
Architecture
Sectored
Interface Type
Serial
Supply Voltage (max)
3.6 V
Supply Voltage (min)
2.7 V
Maximum Operating Current
50 mA
Mounting Style
SMD/SMT
Operating Temperature
+ 85 C
Package / Case
TSOP-56
Memory Configuration
128K X 16
Ic Interface Type
Parallel
Supply Voltage Range
2.7V To 3.6V
Memory Case Style
TSOP
No. Of Pins
56
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
S29GL128P11TFI020
Manufacturer:
SPANSION
Quantity:
1 133
Part Number:
S29GL128P11TFI020
Manufacturer:
SPANSION
Quantity:
20 000
7. The Reset command is required to return to reading array data when device is in the autoselect mode, or if DQ5 goes high (while the device is providing status
8. See
9. The fourth, fifth, and sixth cycles of the autoselect command sequence are read cycles.
10. The data is 00h for an unprotected sector and 01h for a protected sector. See “Autoselect Command Sequence” for more information. This is same as PPB
11. The data value for DQ7 is “1” for a serialized, protected Secured Silicon Sector region and “0” for an unserialized, unprotected region. See
12. Command is valid when device is ready to read array data or when device is in autoselect mode.
13. Command sequence returns device to reading array after being placed in a Write-to-Buffer-Abort state. Full command sequence is required if resetting out of
14. The Unlock-Bypass command is required prior to the Unlock-Bypass-Program command.
15. The Unlock-Bypass-Reset command is required to return to reading array data when the device is in the unlock bypass mode.
16. The system can read and program/program suspend in non-erasing sectors, or enter the autoselect mode, when in the Erase Suspend mode. The Erase
17. The Erase Resume/Program Resume command is valid only during the Erase Suspend/Program Suspend modes.
18. The Exit command returns the device to reading the array.
62
data).
Status Read except that the protect and unprotect statuses are inverted here.
for data and definitions.
abort while in Unlock Bypass mode.
Suspend command is valid only during a sector erase operation.
Table 7.2 on page 17
for device ID values and definitions.
D a t a
S29GL-P MirrorBit
S h e e t
( A d v a n c e
TM
Flash Family
I n f o r m a t i o n )
S29GL-P_00_A3 November 21, 2006
Table 7.3 on page 17