BLM18HG601SN1D Murata, BLM18HG601SN1D Datasheet - Page 198

• Manufacturer Part Number: BLM18HG601SN1D
• Description: EMI/RFI Suppressors & Ferrites 0603 600 OHM
• Manufacturer: Murata

Specifications of BLM18HG601SN1D

• Shielding: Unshielded
• Test Frequency: 100 MHz
• Product: Chip Ferrite Beads
• Impedance: 600 Ohms
• Tolerance: 25 %
• Maximum Dc Current: 200 mAmps
• Maximum Dc Resistance: 1 Ohms
• Operating Temperature Range: - 55 C to + 125 C
• Package / Case: 0603 (1608 metric)
• Termination Style: SMD/SMT
• Dc Resistance Max: 1ohm
• Dc Current Rating: 200mA
• Ferrite Mounting: SMD
• Ferrite Case Style: 0603
• Inductor Case Style: 0603
• No. Of Pins: 2
• Core Material: Ferrite
• Resistance: 1ohm
• Rohs Compliant: Yes
• Operating Temperature Min: -55°C
• Operating Temperature Max: +125°C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

!Note
196
Block Type EMIFILr
1. Cleaning
2. Soldering
3. Other
<Operating Environment>
1. Do not use products in a chemical atmosphere such
2. Do not use products near water, oil or organic
<Storage and Handling Requirements>
1. Storage Period
2. Storage Conditions
Do not use products beyond the rated current and rated
voltage as this may create excessive heat and
deteriorate the insulation resistance.
(1) Storage temperature: -10 to +40˚C
(2) Do not store products in a chemical atmosphere
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please review our product specifications or consult the approval sheet for product specifications before ordering.
Storage and Operating Conditions
Notice (Soldering and Mounting)
Failure and degradation of a product are caused
by the cleaning method. When you clean in conditions
that are not in mounting information, please contact
Murata engineering.
Reliability decreases with improper soldering
methods. Please solder by the standard soldering
conditions shown in mounting information.
Noise suppression levels resulting from Murata's
EMI suppression filters "EMIFIL" may vary,
depending on the circuits and ICs used, type of
noise, mounting pattern, lead wire length, mounting
location, and other operating conditions. Be sure
to check and confirm in advance the noise
suppression effect of each filter, in actual
circuits, etc. before applying the filter in a
commercial-purpose equipment design.
as chlorine gas, acid or sulfide gas.
solvents.
BNX Series should be used within 12 months.
Solderability should be checked if this period is
exceeded.
Rating
Relative humidity: 15 to 85%
Avoid sudden changes in temperature and humidity.
such as chlorine gas, acid or sulfide gas.
Lead Type
!Caution/Notice
!Caution
Notice
Mar.28,2011
C31E.pdf