ISL9208EVAL2Z Intersil, ISL9208EVAL2Z Datasheet - Page 14

• Manufacturer Part Number: ISL9208EVAL2Z
• Description: EVAL BOARD 2 FOR ISL9208
• Manufacturer: Intersil

Specifications of ISL9208EVAL2Z

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Then, this screen will come up:
Select “Install from a list or specific location” and click “Next”
A screen like the next one will come up:
Browse for the Software in directory “ISL9208_16 Eval Kit
SW and docs” folder then click “Next”.
14
Application Note 1444
This should install the software, eventually bringing up the
following screen:
Click “Finish” and you’re done.
Appendix 2
Communication Troubleshooting
IF THE GUI STARTS UP WITH ALL ITEMS “GRAYED
OUT”
Power Supply Troubleshooting
IF RGO DOES NOT HAVE THE CORRECT VOLTAGE
ISL9208 Troubleshooting
IF THE AO VOLTAGES ARE READING INCORRECTLY
AT THE AO PIN
1. Check that the I
2. Check that the board is powered and that the RGO
3. If the RGO voltage is not powered to the right voltage,
4. Make sure that the board drivers are installed correctly.
5. Use a scope to see that the I
1. Check that the voltage on each of the input terminals are
2. Check that there is no unexpected load on the RGO
1. Check that all cell balance outputs are off.
2. Make sure that there is no series resistance between the
voltage is ~3.3V.
move to the power supply troubleshooting section.
On the DeVaSys USB to I
should be one red LED and one green LED lit.
at the board. Monitor the SCL and the SDA lines while
initiating a read of the ISL9208 status register. Set the
scope to single trigger on the falling edge of SCL.
between 2.6V and 4.5V.
output.
battery and the input pins of the ISL9208EVAL2Z board
and that the input voltage is between 2.6V and 4.3V.
2
C cable is connected properly.
2
C interface board, there
2
C communication is correct
December 15, 2008
AN1444.0